Track Arm - Install
Installation Procedure
- Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
- Use two persons to position track arm (6). Install pin (13). Position bar (15) and install two bolts (14). Position washer (12) and install three bolts (11) .
Show/hide table
Illustration 1 | g00475215 |
- Install pin (10) into axle housing (9) .
Note: The axle housing may need to be lifted in order to install the pin.
Show/hide table
Illustration 2 | g00474848 |
- Position washer (8) and install three bolts (7) into axle housing (9) .
Show/hide table
Illustration 3 | g00474868 |
- Position bar (3) and install two bolts (2). Connect hose assemblies (4) and (5) to track arm (6) .
Show/hide table
Illustration 4 | g00472370 |
- Lower the machine and remove two jacks (1) .
Show/hide table
Illustration 5 | g00471813 |
Caterpillar Information System:
D11R Track-Type Tractor Machine Systems Ripper Lift Cylinder - Remove and Install
D11R Track-Type Tractor Machine Systems Ripper Frame - Remove and Install
D11R Track-Type Tractor Machine Systems Ripper Control Valve - Remove
D11R Track-Type Tractor Machine Systems Ripper Control Valve - Install
D11R Track-Type Tractor Machine Systems Ripper Control Valve - Disassemble
D11R Track-Type Tractor Machine Systems Ripper Control Valve - Assemble
D11R Track-Type Tractor Machine Systems Ripper Carriage (Beam) - Remove and Install
D11R Track-Type Tractor Machine Systems Refrigerant Evaporator Core - Remove and Install
D11R Track-Type Tractor Machine Systems Refrigerant Condenser - Remove and Install
D11R Track-Type Tractor Machine Systems Refrigerant Compressor - Remove and Install
D11R Track-Type Tractor Machine Systems Quick-Drop Valve - Remove
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Steering System Machine Preparation for Troubleshooting
D11R Track-Type Tractor Machine Systems Ripper Pin Puller Control Valve - Remove and Install
D11R Track-Type Tractor Machine Systems Ripper Pin Puller Cylinder - Remove and Install
D11R Track-Type Tractor Machine Systems Ripper Tilt Cylinder - Remove and Install
D11R Track-Type Tractor Machine Systems Rollover Protective Structure (ROPS) - Remove and Install
D11R Track-Type Tractor Machine Systems Seat - Remove and Install
953C Track-Type Loader Machine Systems Tilt Cylinder - Remove
D9R Track-Type Tractor Alternator Belt - Inspect/Adjust
615C Series II Wheel Tractor-Scraper Wheel Tractor Power Train Track Arm Bearings - Remove and Install
627F Wheel Tractor-Scraper Suction Screen (Transmission Scavenge) - Clean
D11R Carrydozer Track-Type Tractor Bulldozer - Install
D11R Carrydozer Track-Type Tractor Bulldozer - Remove
D11R Track-Type Tractor Machine Systems Pilot Control Valve - Assemble