- Move the hydraulic lockout control to the LOCKED position.
- Turn the engine start switch to the OFF position in order to stop the engine. Remove the engine start switch key.
- Turn the battery disconnect switch to OFF and remove the disconnect switch key.
- Remove the ether starting aid cylinder. See Operation and Maintenance Manual, "Ether Starting Aid Cylinder - Replace" for the removal procedure.
- Lock the door and the access covers. Attach any vandalism protection.
- Cover the exhaust opening.
Show/hide table
NOTICE Do not allow the turbocharger to rotate while the engine is not operating. Damage to the turbocharger can result.
Note: Before you remove the excavator from the transport machine, remove the protective covering from the exhaust opening.
Show/hide tableIllustration 2 g01410764 Typical example - Chock the tracks and secure the machine with tie-downs. Make sure that you use the proper rated wire cable.
Use the front towing eyes on the lower frame, the rear towing eyes on the lower frame, and the rear towing eye that is on the upper frame.
Securely fasten all loose parts and all removed parts to the trailer or to the rail car.
When the engine is stopped, the swing parking brake is automatically applied. This prevents the upper structure from swinging.
Illustration 1 | g01075262 |
NOTICE |
---|
In freezing weather, protect the cooling system with antifreeze, to the lowest outside expected temperature on the travel route. Or, drain the cooling system completely. |