Alternator - Remove and Install
拆卸步骤
- 打开发动机罩 (1) 。
Show/hide table
图 1 | g01622066 |
- 将蓄电池断路开关转到断开位置。
- 拆开卡箍 (2) 和软管 (3) 。
Show/hide table
图 2 | g01622074 |
- 松开螺栓 (4) 。
Show/hide table
图 3 | g01622075 |
- 从交流发电机 (11) 上拆下螺栓 (8) 。 请参阅操作和保养手册, "皮带检查 / 调整 / 更换"。
Show/hide table
图 4 | g01622076 |
- 断开线束组件 (5) 、 (7) 、 (9) 和 (10) 。
- 拆下螺栓 (6) 和 (12) 。 拆下交流发电机 (11) 。
安装步骤
- 安置交流发电机 (11) 并安装螺栓 (6) 和 (12) 。
Show/hide table
图 5 | g01622076 |
- 连接线束组件 (5) 、 (7) 、 (9) 和 (10) 。
- 将皮带 (8) 安装到交流发电机 (11) 上。 请参阅操作和保养手册, "皮带检查 / 调整 / 更换"。
- 拧紧螺栓 (4) 。
Show/hide table
图 6 | g01622075 |
- 连接软管 (3) 和卡箍 (2) 。
Show/hide table
图 7 | g01622074 |
- 将蓄电池断路开关转到接通位置。
- 关闭发动机罩 (1) 。
Show/hide table
图 8 | g01622066 |
Caterpillar Information System:
2008/08/11 New C18 Cylinder Liners and O-ring Seals are Used {1201, 1216, 1216}
C4.2 and C6.4 Engines for Caterpillar Built Machines Fuel Injection Pump
345C Excavator (Ultra High Demolition) Hydraulic System Swing Hydraulic System
345C Excavator (Ultra High Demolition) Hydraulic System Cylinders (Boom, Stick and Bucket)
315D and 318D Excavators Machine System Specifications Solenoid Valve (Swing Motor)
323D Excavator Lifting Capacities
325C Excavator Machine Systems Sprocket - Remove and Install
Installation Procedure for 260-7984 Pilot Lines Gp (PILOT OIL PRESSURE){5057, 5059, 6307} Installation Procedure for 260-7984 Pilot Lines Gp (PILOT OIL PRESSURE){5057, 5059, 6307}
GLC85 Forestry Grapple Rotator Manifold Leakage - Test
GLC85 Forestry Grapple Hydraulic Rotator Cycle Time - Check
345C Excavator (Ultra High Demolition) Hydraulic System Control Valve (Stick Lowering)
GLC85 Forestry Grapple Rotator Manifold - Disassemble
345C Excavator (Ultra High Demolition) Hydraulic System Travel Hydraulic System
323D MHPU Mobile Hydraulic Power Unit Securing the Machine
307D Excavator Engine Supplement Refrigerant Compressor - Remove and Install
2008/08/11 Procedure is Available to Improve the Mounting Locations of the Grab Handle. {7301}
307D Excavator Machine Systems Check Valve (Cooler Bypass) - Remove
307D Excavator Machine Systems Check Valve (Cooler Bypass) - Install
323D MHPU Mobile Hydraulic Power Unit Capacities (Refill)
319D Excavator Machine System Specifications Boom - 5.3 m (17.39 ft)
2008/08/18 An Improved Stick Regeneration Valve is Now Available for Certain Excavators {5051}
325D and 329D Excavators and 325D Material Handler Machine System Specifications Stick - 7.85 m (25.755 ft)
345C Excavator (Ultra High Demolition) Hydraulic System Control Valve (Straight Travel)
314D CR Hydraulic Excavator C4.2 Engine Supplement Coolant Tank (Expansion) - Remove and Install