Valve Guides
Usage:
Remove Valve Guides
Start By:
a. remove valves
1. Use Tool (A) to remove the valve guides.
Install Valve Guides
1. Put clean engine oil on the outside of the valve guide.
2. Use Tooling (A) to install the valve guides.
3. After installation, the inside diameter of the valve guide must be 9.487 ± 0.025 mm (.3735 ± .0010 in). The maximum diameter of used guides is 8.538 mm (.3361 in).
End By:
a. install valves
Caterpillar Information System:
3406C GENERATOR SET ENGINE Bridge Dowels
3406C GENERATOR SET ENGINE Valve Seat Inserts
3406C GENERATOR SET ENGINE Inlet & Exhaust Valves
3406C GENERATOR SET ENGINE Spacer Plate
3406C GENERATOR SET ENGINE Cylinder Head Assembly
3406C GENERATOR SET ENGINE Aftercooler Housing
3406C GENERATOR SET ENGINE Aftercooler Core
3406C GENERATOR SET ENGINE Fuel Injection Nozzles & Adapters
3406C GENERATOR SET ENGINE Valve Lifters
3406C GENERATOR SET ENGINE Rocker Shaft Assemblies
3406C GENERATOR SET ENGINE Rocker Shaft Assemblies & Push Rods
3406C GENERATOR SET ENGINE Accessory Drive
3406C GENERATOR SET ENGINE Oil Pan
3406C GENERATOR SET ENGINE Flywheel
3406C GENERATOR SET ENGINE Flywheel Housing
3406C GENERATOR SET ENGINE Oil Pump
3406C GENERATOR SET ENGINE Piston Cooling Tubes
3406C GENERATOR SET ENGINE Camshaft
3406C GENERATOR SET ENGINE Camshaft Bearings
3406C GENERATOR SET ENGINE Connecting Rod Bearings
3406C GENERATOR SET ENGINE Crankshaft Main Bearings
3406C GENERATOR SET ENGINE Crankshaft
3406C GENERATOR SET ENGINE Crankshaft Front Seal & Wear Sleeve
3406C GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve