Flywheel
Usage:
Remove & Install Flywheel
1. Fasten a hoist to Tool (A). Install Tool (A) to the flywheel.
2. Remove bolts (1) that hold the flywheel to the crankshaft. Remove flywheel (2). The weight is approximately 65 kg (143 lb).
3. Remove gear (3) from the flywheel if necessary.
NOTE: The following steps are for installation of the flywheel.
4. Heat gear (3) to a maximum temperature of 315 °C (600 °F), and install it on flywheel (2) so the chamfer of the gear teeth will be toward the electric starting motor pinion when the flywheel is installed.
5. Fasten a hoist and Tool (A) to flywheel (2), and put it in position on the dowel of the crankshaft.
6. Put clean engine oil on the threads of bolts (1) that hold the flywheel to the crankshaft and install the bolts.
Caterpillar Information System:
3406C GENERATOR SET ENGINE Oil Pan
3406C GENERATOR SET ENGINE Valve Guides
3406C GENERATOR SET ENGINE Bridge Dowels
3406C GENERATOR SET ENGINE Valve Seat Inserts
3406C GENERATOR SET ENGINE Inlet & Exhaust Valves
3406C GENERATOR SET ENGINE Spacer Plate
3406C GENERATOR SET ENGINE Cylinder Head Assembly
3406C GENERATOR SET ENGINE Aftercooler Housing
3406C GENERATOR SET ENGINE Aftercooler Core
3406C GENERATOR SET ENGINE Fuel Injection Nozzles & Adapters
3406C GENERATOR SET ENGINE Valve Lifters
3406C GENERATOR SET ENGINE Rocker Shaft Assemblies
3406C GENERATOR SET ENGINE Flywheel Housing
3406C GENERATOR SET ENGINE Oil Pump
3406C GENERATOR SET ENGINE Piston Cooling Tubes
3406C GENERATOR SET ENGINE Camshaft
3406C GENERATOR SET ENGINE Camshaft Bearings
3406C GENERATOR SET ENGINE Connecting Rod Bearings
3406C GENERATOR SET ENGINE Crankshaft Main Bearings
3406C GENERATOR SET ENGINE Crankshaft
3406C GENERATOR SET ENGINE Crankshaft Front Seal & Wear Sleeve
3406C GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3406C GENERATOR SET ENGINE Cylinder Liners
3406C GENERATOR SET ENGINE Pistons & Connecting Rod Assemblies