Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Prior to installation, lubricate all seals with clean oil.
- Install spring (14) into control manifold (4) .
Illustration 1 | g01267207 |
Illustration 2 | g01267189 |
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Install a new O-ring seal onto plug (13) . Install plug (13) into control manifold (4) .
- Install a new O-ring seal onto plug (10) . Install valve (11) , spring (12) , and plug (10) into manifold (4) .
Illustration 3 | g01267188 |
Illustration 4 | g01267187 |
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Install new O-ring seals (6) , (7) , (8) , and (9) onto valve (2) .
Illustration 5 | g00913702 |
- Install a new O-ring seal onto plug (3) . Install plug (3) , valves (2) , and bolts (1) onto control manifold (4) . Tighten bolts (1) to a torque of 4.0 ± 0.4 N·m (35.4 ± 3.5 lb in). Install accumulator (5) into control manifold (4) .
Illustration 6 | g01267182 |
End By: Install the pilot valve (oil manifold). Refer to Disassembly and Assembly, "Control Manifold (Pilot Oil) - Install".