Installation Procedure
Required Tools     | |||
Tool     | Pt. No.     | Description     | Qty     |
A     | 4C-6486     | Stand     | 4     |
8S-7641 | Tube     | 2     | |
8S-7621 | Tube     | 2     | |
8S-7625 | Collar     | 1     | |
8S-8048 | Saddle     | 4     | |
8S-7615 | Pin     | 4     | |
189-0411 | Shackle As     | 1     | |
- | Pipe (51 mm (2 inch) OD)     | 1     | |
B     | 138-7575     | Link Bracket     | 2     |
C     | 169-6969     | Threaded Stud (M16 X 2 X 400 mm)     | 1     |
Note: Inspect all O-ring seals for wear or for damage. Replace the components, if necessary.
NOTICE |
---|
Keep all parts clean from contaminants. Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components. To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly. Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Install Tooling (B). Attach a suitable lifting device to piston motor (6). The piston motor weighs approximately 91 kg (200 lb).
Illustration 1 | g01013649 |
- Position the piston motor and install Tooling (C). Slide the piston motor into the work tool.
- Remove Tooling (B) and (C). Install bolts (2), (5), and (3) .
Illustration 2 | g01013644 |
- Install the O-ring seals and connect hose assemblies (4) .
- Install nuts (1) .
Illustration 3 | g01013643 |
- Remove the work tool from Tooling (A) .