Final Drive Oil - Change
Show/hide table
Illustration 1 | g01012500 |
This final drive is for the machine serial number (S/N: XJA1-UP). |
Show/hide table
Illustration 2 | g01021489 |
This final drive is for the machine serial number (S/N: PAN1-UP). |
- Turn the hub until the fill/drain plug is at the lowest position.
- Remove the dirt that is around the fill/drain plug.
- Remove the fill/drain plug. Drain the oil into a suitable container.
Note: Dispose of used oil according to local regulations.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
- Turn the hub until the opening of the fill/drain plug is horizontal.
Show/hide table
Illustration 3 | g01104796 |
This final drive is for the machine serial number (S/N: XJA1-UP). |
Show/hide table
Illustration 4 | g01022414 |
This final drive is for the machine serial number (S/N: PAN1-UP). |
- Fill the final drive with lubricant to the bottom of the opening of the fill/drain plug. See Operation and Maintenance Manual, "Capacities (Refill)".
- Inspect the O-ring seal. If damage or wear is noticed on the O-ring seal, replace the seal.
- Install the O-ring seal. Install the fill/drain plug.
- Repeat Steps 1 through 7 for the remaining three axle hubs.
Caterpillar Information System:
321C LCR Excavator Machine Systems Boom Lighting - Remove and Install
M325C Material Handler Operation Information
315C Excavator Machine Systems Bucket Cylinder - Remove and Install
C4.4 Industrial Engine Increased Engine Oil Temperature - Inspect
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
M325C Material Handler Fuel System Water Separator Element - Replace
M325C Material Handler Final Drive Oil Level - Check
M325C Material Handler Final Drive Oil Sample - Obtain
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
321C CR Excavator Engine Supplement Fan - Remove and Install
321C CR Excavator Engine Supplement Muffler - Remove and Install
321C CR Excavator Engine Supplement Fan Guard - Remove and Install
321C LCR Excavator Machine Systems Pilot Valve (Travel) - Remove
321C LCR Excavator Machine Systems Pilot Valve (Travel) - Install
321C LCR Excavator Machine Systems Pilot Valve (Joystick) - Remove
321C LCR Excavator Machine Systems Pilot Valve (Joystick) - Install
315C Excavator Machine Systems Stick Cylinder - Remove and Install
2003/08/18 A New Egress Ladder is Used {7254, 7255}
345B Excavator Hydraulic System Counterweight (Removal and Installation Hydraulic System)
315C Excavator Machine Systems Boom Cylinder - Remove and Install
M325D MH Material Handler Window Washer Reservoir - Fill
2003/09/15 An Improved Alternator Belt is Used {1357}
2003/10/01 An Improved Alternator Belt is Used {1357}
321C LCR Excavator Machine Systems Swivel - Remove