Final Drive Oil Level - Check
Show/hide table
Illustration 1 | g01104796 |
This final drive is for the machine serial number (S/N: XJA1-UP). |
Show/hide table
Illustration 2 | g01022414 |
This final drive is for the machine serial number (S/N: PAN1-UP). |
- Turn the hub until the opening of the fill/drain plug is horizontal, as shown.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
- Remove the dirt that is around the fill/drain plug.
- Remove the fill/drain plug.
- Fill the final drive with lubricant to the bottom of the opening of the fill/drain plug. See Operation and Maintenance Manual, "Capacities (Refill)".
- Inspect the O-ring seal. If damage or wear is noticed on the O-ring seal, replace the seal.
- Install the O-ring seal. Install the fill/drain plug.
- Repeat Steps 1 through 6 for the remaining three axle hubs.
Caterpillar Information System:
M325C Material Handler Final Drive Oil Sample - Obtain
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
321C CR Excavator Engine Supplement Fan - Remove and Install
321C CR Excavator Engine Supplement Muffler - Remove and Install
321C CR Excavator Engine Supplement Fan Guard - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
PC404 Cold Planer Work Tool Troubleshooting Information
2003/08/11 The Reliability of the Backup Alarm Assembly Is Improved {7429}
2003/12/22 The Addition of a Heat Shield Plate Protects the Engine Valve Cover {1061, 1062, 1107}
321C CR Excavator Engine Supplement Turbocharger - Install
321C CR Excavator Engine Supplement Turbocharger - Remove
322C Forest Machine Machine System Specifications Heel Cylinder
M325C Material Handler Fuel System Water Separator Element - Replace
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C4.4 Industrial Engine Increased Engine Oil Temperature - Inspect
315C Excavator Machine Systems Bucket Cylinder - Remove and Install
M325C Material Handler Operation Information
321C LCR Excavator Machine Systems Boom Lighting - Remove and Install
M325C Material Handler Final Drive Oil - Change
321C LCR Excavator Machine Systems Pilot Valve (Travel) - Remove
321C LCR Excavator Machine Systems Pilot Valve (Travel) - Install
321C LCR Excavator Machine Systems Pilot Valve (Joystick) - Remove
321C LCR Excavator Machine Systems Pilot Valve (Joystick) - Install
315C Excavator Machine Systems Stick Cylinder - Remove and Install