G3500 Engines Caterpillar

Removal Procedure

Show/hide table

Illustration 1	g01248557

Show/hide table

Illustration 2	g01248562

1. Loosen screws (1) on the cover of panel (3). Open the cover in order to gain access to the back of service meter (2).

2. Place an identification mark on all of the harness assemblies for the installation procedure.

3. Remove the nuts and the harness assemblies from the bracket. Remove the bracket and service meter (2) from panel (3).

4. Remove the clip and disconnect connector (4). Loosen locknut (5) and remove sensor (6).

Installation Procedure

Show/hide table

Illustration 3	g01248562

Show/hide table

Illustration 4	g01248557

1. Install the bracket, the nuts, and service meter (2) in panel (3).

2. Install sensor (6) until the sensor touches the tooth of the flywheel ring gear. Turn the sensor in the counterclockwise direction for 1/2 turn. Tighten locknut (5) to a torque of 45 ± 7 N·m (33 ± 5 lb ft). The clearance of the sensor and the flywheel ring gear should be 0.69 ± 0.14 mm (0.027 ± 0.006 inch).

3. Install connector (4) and install the clip.

4. Close the cover and tighten screws (1).