Flywheel Housing - Rear Power Take-Off (RPTO)
Show/hide table
Illustration 1 | g01437772 |
(2) Flywheel housing |
Show/hide table
Illustration 2 | g01437775 |
Section A-A |
Show/hide table
Illustration 3 | g01437776 |
Detail D |
(1) Bearing
- The split in the bearing should be located at angle (A). ... 23 ± 10 degrees
- The bearing should be installed to depth (E). ...
1.5 ± 0.5 mm (0.06 ± 0.02 inch) - The bearing should be installed to depth (E). ...
(3) Dowel
- The dowels should extend beyond the surface of the flywheel housing by distance (F). ...
3.0 ± 0.2 mm (0.12 ± 0.01 inch)
Show/hide table
Illustration 4 | g01437777 |
Section B-B |
Apply 1U-8846 Sealant on the gasket surface of the flywheel housing except in area (G). Assemble the flywheel housing to the cylinder block and tighten within ten minutes of applying the sealant.
Caterpillar Information System:
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System Position Sensor (Transmission Gear) - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Flywheel Housing
C-10 and C-12 Truck Engines Belt Tensioner
3406E On-Highway Engine Water Temperature Regulator - Remove and Install
3406C Engines for Caterpillar Built Machines Fuel Injection Pump Housing
3406C (PEEC III) Truck Engine Engine Oil Pressure
3406C (PEEC III) Truck Engine Engine Oil Pan
3406C (PEEC III) Truck Engine Engine Oil Filter Base
3306B Industrial Engine Refill Capacities
C-10 and C-12 Industrial Engines Inlet Air Temperature Sensor
3306B Industrial Engine Starting the Engine
3406E Truck Engines Electric Starting Motor
3306B Industrial Engine Turbocharger
C-10 and C-12 Truck Engines Belt Tensioner
3412E and C30 Engines Engine Design
3306B Industrial Engine Cylinder Head Valves
3612 and 3616 Fast Vessel Engines Starting the Engine
3406E Truck Engine General Information
3306B Industrial Engine Engine Crankcase Breather - Clean
3600 Heavy Fuel Engines After Starting Engine
3408E and 3412E Industrial Engines Crankshaft
3600 Heavy Fuel Engines Engine Speed Governing
3412E and C30 Engines Piston and Rings
3406E Truck Engine Electronic Control System Components