Engine Oil Pan
Show/hide table
Illustration 1 | g00492776 |
Rear Sump |
(1) Install the gasket for the magnetic drain plugs with the seam against the oil pan. Tighten the magnetic drain plugs to the following torque. ... 70 ± 15 N·m (50 ± 10 lb ft)
Note: Change all drain plug gaskets and torque all drain plugs at each oil change.
(2) Tighten the bolts that hold the oil pan to the cylinder block to the following torque. ... 55 ± 10 N·m (40 ± 7 lb ft)
Caterpillar Information System:
3406C (PEEC III) Truck Engine Engine Oil Filter Base
3306B Industrial Engine Refill Capacities
C-10 and C-12 Industrial Engines Inlet Air Temperature Sensor
3306B Industrial Engine Starting the Engine
3406E Truck Engines Electric Starting Motor
G3612 and G3616 Engines Pressure Relief Valve Setting
3406E On-Highway Engine Electric Starting Motor - Remove and Install
3406C Engines for Caterpillar Built Machines Fuel Injection Lines
3406E Truck Engines Engine Support (Front)
3306B Industrial Engine Air Starting System
3408E and 3412E Engines for Caterpillar Built Machines Coolant Temperature Sensor
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
3406C (PEEC III) Truck Engine Engine Oil Pressure
3406C Engines for Caterpillar Built Machines Fuel Injection Pump Housing
3406E On-Highway Engine Water Temperature Regulator - Remove and Install
C-10 and C-12 Truck Engines Belt Tensioner
3176C and 3196 Engines for Caterpillar Built Machines Flywheel Housing
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System Position Sensor (Transmission Gear) - Remove and Install
C-10 and C-12 Truck Engines Flywheel Housing - Rear Power Take-Off (RPTO)
3306B Industrial Engine Turbocharger
C-10 and C-12 Truck Engines Belt Tensioner
3412E and C30 Engines Engine Design
3306B Industrial Engine Cylinder Head Valves
3612 and 3616 Fast Vessel Engines Starting the Engine