Flywheel Housing
Show/hide table
| |
| Illustration 1 | g00871606 |
|
Torque sequence | |
Show/hide table
| |
| Illustration 2 | g01437738 |
|
(13) Flywheel housing
(15) Cylinder block | |
(14) Apply 1U-8846 Sealant on the gasket surface of the flywheel housing. Assemble the flywheel housing to the cylinder block and tighten within ten minutes of applying the sealant. Use the torque sequence that is shown in Illustration 1 to tighten the bolts.
Caterpillar Information System:
C-10 and C-12 Truck Engines Belt Tensioner
3406E On-Highway Engine Water Temperature Regulator - Remove and Install
3406C Engines for Caterpillar Built Machines Fuel Injection Pump Housing
3406C (PEEC III) Truck Engine Engine Oil Pressure
3406C (PEEC III) Truck Engine Engine Oil Pan
3406C (PEEC III) Truck Engine Engine Oil Filter Base
3306B Industrial Engine Refill Capacities
C-10 and C-12 Industrial Engines Inlet Air Temperature Sensor
3306B Industrial Engine Starting the Engine
3406E Truck Engines Electric Starting Motor
G3612 and G3616 Engines Pressure Relief Valve Setting
3406E On-Highway Engine Electric Starting Motor - Remove and Install
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System Position Sensor (Transmission Gear) - Remove and Install
C-10 and C-12 Truck Engines Flywheel Housing - Rear Power Take-Off (RPTO)
3306B Industrial Engine Turbocharger
C-10 and C-12 Truck Engines Belt Tensioner
3412E and C30 Engines Engine Design
3306B Industrial Engine Cylinder Head Valves
3612 and 3616 Fast Vessel Engines Starting the Engine
3406E Truck Engine General Information
3306B Industrial Engine Engine Crankcase Breather - Clean
3600 Heavy Fuel Engines After Starting Engine
3408E and 3412E Industrial Engines Crankshaft
3600 Heavy Fuel Engines Engine Speed Governing