After Starting Engine
After the engine is started and the warm-up is completed, the engine can be operated at low rpm and low load. The engine should reach operating temperature before the vessel enters open water.
Note: After the engine has been installed or rebuilt, it is important to follow a break-in procedure. It is also important to monitor the performance of the engine closely. See Special Instruction, REHS1321, "Break-In Procedure for New Cylinder Liners and Piston Rings".
- DO NOT apply a load to the engine or increase the rpm until the oil pressure gauge indicates a minimum of 160 kPa (23 psi) at low idle rpm. Check the gauges during the warm-up. Complete a walk-around inspection. Check for leaks and unusual noises.
- Ensure that the gauges are in the normal ranges for the engine rpm. After verifying that the engine systems are normal, engage the driven equipment. Begin operating the engine at low load. Continue to check the gauges and the driven equipment. Operate the engine at a low load until the engine reaches normal operating temperatures.
- After normal oil pressure and temperature are reached and the jacket water coolant temperature reaches 80 °C (176 °F), the engine may be operated at full load. Increase the load, as required.
Caterpillar Information System:
3306C Truck Engine Flywheel
3618 Engine Before Starting Engine
3306C Engines for Caterpillar Built Machines Engine Trunnion
3512B Engine and SPF343, SPS343 and SPT343 Pumpers Fuel Pressure Sensor
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Engine Oil Pressure Sensor
3618 Engine Engine Oil and Filter - Change
3306C Truck Engine Shutoff Pivot Lever
3306B Industrial Engine Ether Atomizers
3500B Locomotive Engines Auxiliary Drive Coupling
3306C Truck Engine Gear Group (Rear) - PTO
3618 Engine Engine Speed Governing
Removal And Installation Of The Hydraulic Electronic Unit Injectors{1290} Removal And Installation Of The Hydraulic Electronic Unit Injectors{1290}
3618 Engine Starting the Engine
3306C Truck Engine Flywheel
3618 Engine Gauges and Indicators
3618 Engine Alarms and Shutoffs
3306C Truck Engine Flywheel
G3612 and G3616 Engines General Information (Air Starting System)
3618 Engine Engine Power Ratings
3618 Engine Sensors and Electrical Components
322B, 322B L, 325B and 325B L Excavators Shear Operation - If Equipped
3618 Engine Safety Messages
3306C Truck Engine Water Pump
Oil Renewal System Electronic Control System