Flywheel
Show/hide table
 | |
| Illustration 1 | g00337720 |
(1) Ring gear
(2) Flywheel
(3) Torque for the flywheel bolts ... 215 ± 40 N·m (160 ± 30 lb ft)
Install ring gear (1) on the flywheel with chamfer side (4), as shown.
Note: Do not heat the ring gear to more than 320° C (608° F) before the ring gear is installed on the flywheel.
Caterpillar Information System:
3618 Engine Starting the Engine
3618 Engine After Starting Engine
3306C Truck Engine Flywheel
3618 Engine Before Starting Engine
3306C Engines for Caterpillar Built Machines Engine Trunnion
3512B Engine and SPF343, SPS343 and SPT343 Pumpers Fuel Pressure Sensor
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Engine Oil Pressure Sensor
3618 Engine Engine Oil and Filter - Change
3306C Truck Engine Shutoff Pivot Lever
3306B Industrial Engine Ether Atomizers
3500B Locomotive Engines Auxiliary Drive Coupling
3306C Truck Engine Gear Group (Rear) - PTO
3618 Engine Gauges and Indicators
3618 Engine Alarms and Shutoffs
3306C Truck Engine Flywheel
G3612 and G3616 Engines General Information (Air Starting System)
3618 Engine Engine Power Ratings
3618 Engine Sensors and Electrical Components
322B, 322B L, 325B and 325B L Excavators Shear Operation - If Equipped
3618 Engine Safety Messages
3306C Truck Engine Water Pump
Oil Renewal System Electronic Control System
3306C Truck Engine Valve Rocker Arms and Lifters
3412 Generator Set Engines Engine Design