After Starting Engine
对于新安装的发动机或最近才重新修配的发动机,要小心监视发动机,以便检测出任何异常的发动机性能。
一分钟后发动机速度可以从低怠速提升到额定转速。
使用管道天然气的发动机有能力在30秒钟内爬升到满负荷。 对于使用生物燃气的发动机,延长负荷爬升的时间将有助于提供爆震防护。 加载时避免发生爆震。 一般来讲,从无负荷运行到满负荷运行可以不出任何问题地在5至10 分钟内实现
可能需要先施加一些负载以便获得正常的工作温度。 操作人员可以手动提升负载。 对于自动加载,可以使用可编程逻辑控制。
- 将发动机转速提高到额定转速。
- 确保水套水的出口温度达到77 °C (170 °F)。 确保仪表组在此转速下的正常范围。
- 闭合主断路器以便施加负载。
- 提高发动机转速。 确保仪表组在此转速下的正常范围。
- 在被驱动设备无负荷的情况下接合被驱动设备。
发动机可以在水套水温度达到77 °C (170 °F)之前,被加载到满负荷的50%。 该温度通常在2至4分钟就可以达到。 在达到该温度之后,再开始提升发动机的负荷至满负荷。
- 在水套水温度达到77 °C (170 °F)之后,提升发动机的负荷至满负荷。 可能需要5分钟。
Caterpillar Information System:
3500B and 3500B High Displacement Generator Set Engines Electronic Control System Components
G3500 Engines Starting the Engine
345B Excavator Swing Gear - Lubricate
3500B and 3500B High Displacement Generator Set Engines Electronic Control Module (ECM)
3408B and 3412C Generator Set Engines Basic Block
G3500 Engines Before Starting Engine
G3300 Engines Cold Weather Starting
3408B and 3412C Generator Set Engines Engine Design
3618 Engine Aftercooler
3306B Industrial Engine Engine Air Cleaner Element (Dual Element) - Clean/Replace
3618 Engine Turbocharger
G3500 Engines Speed Sensor - Clean/Inspect
3508, 3512, and 3516 Generator Sets Engine Valve Lash - Inspect/Adjust
G3300 Engines Engine Operation
G3500 Engines Emergency Stopping
C15 and C18 Petroleum Generator Sets Engine Air Precleaner - Check/Clean
3500B and 3500B High Displacement Generator Set Engines Cold Cylinder Cutout
G3500 Engines Manual Stop Procedure
G3300 Engines Exhaust Piping - Inspect
G3300 Engines Fuel System Fuel Filter Differential Pressure - Check
3408B and 3412C Generator Set Engines Lubrication System
G3500 Engines Valve Stem Projection - Measure/Record
G3500 Engines Overhaul (Top End)
3408B and 3412C Generator Set Engines Air Inlet And Exhaust System