Service Meter
Usage:
Remove & Install Service Meter
1. Remove two bolts and clamps (1), and remove service meter (2).
Typical Example
2. Remove coupling (4) and O-ring seal (3) from service meter (2).
NOTE: The following steps are for installation of the service meter.
3. Put O-ring seal (3) and coupling (4) in position on service meter.
4. Put clean engine oil on the coupling and O-ring seal.
5. Put service meter (2) in position, and install two bolts and clamps (1).
Caterpillar Information System:
3406C MARINE ENGINE Instrument Panel
3406C MARINE ENGINE Engine Rear Support
3406C MARINE ENGINE Engine Front Support
3406C MARINE ENGINE Crankshaft Vibration Damper & Pulley
3406C MARINE ENGINE Air Cleaner
3406C MARINE ENGINE Dipstick Assembly
3406C MARINE ENGINE Engine Lifting Brackets
3406C MARINE ENGINE Introduction
3408C & 3412C INDUSTRIAL ENGINES Testing & Adjusting
3408C & 3412C INDUSTRIAL ENGINES Systems Operation
3408C & 3412C INDUSTRIAL ENGINES Circuit Breaker
3408C & 3412C INDUSTRIAL ENGINES Switches
3406C MARINE ENGINE Tachometer Drive
3406C MARINE ENGINE Electric Starting Motor
3406C MARINE ENGINE Sump Pump
3406C MARINE ENGINE Fuel Priming Pump
3406C MARINE ENGINE Fuel Filter Base
3406C MARINE ENGINE Raw Water Pump
3406C MARINE ENGINE Accessory Drive
3406C MARINE ENGINE Fuel Transfer Pump
3406C MARINE ENGINE Fuel Injection Pump & Governor Drive
3406C MARINE ENGINE Governor & Fuel Pump Drive
3406C MARINE ENGINE Fuel Ratio Control
3406C MARINE ENGINE Fuel Injection Lines