Tachometer Drive
Usage:
Remove & Install Tachometer Drive
Start By:
a. remove service meter
1. Disconnect the tachometer cable from the tachometer drive.
2. Remove two bolts and clamps (2), and remove tachometer drive (1).
3. Remove coupling (4) and O-ring seal (3) from tachometer drive (1).
NOTE: The following steps are for installation of the tachometer drive.
4. Put coupling (4) and O-ring seal (3) in position on tachometer drive (1).
5. Put clean oil on the coupling and O-ring seal.
6. Align coupling (4) with the shaft in the governor, and install tachometer drive (1).
7. Install bolts and clamps (2) that hold the tachometer drive to the governor.
8. Connect tachometer cable to the tachometer drive.
End By:
a. install service meter
Caterpillar Information System:
3406C MARINE ENGINE Service Meter
3406C MARINE ENGINE Instrument Panel
3406C MARINE ENGINE Engine Rear Support
3406C MARINE ENGINE Engine Front Support
3406C MARINE ENGINE Crankshaft Vibration Damper & Pulley
3406C MARINE ENGINE Air Cleaner
3406C MARINE ENGINE Dipstick Assembly
3406C MARINE ENGINE Engine Lifting Brackets
3406C MARINE ENGINE Introduction
3408C & 3412C INDUSTRIAL ENGINES Testing & Adjusting
3408C & 3412C INDUSTRIAL ENGINES Systems Operation
3408C & 3412C INDUSTRIAL ENGINES Circuit Breaker
3406C MARINE ENGINE Electric Starting Motor
3406C MARINE ENGINE Sump Pump
3406C MARINE ENGINE Fuel Priming Pump
3406C MARINE ENGINE Fuel Filter Base
3406C MARINE ENGINE Raw Water Pump
3406C MARINE ENGINE Accessory Drive
3406C MARINE ENGINE Fuel Transfer Pump
3406C MARINE ENGINE Fuel Injection Pump & Governor Drive
3406C MARINE ENGINE Governor & Fuel Pump Drive
3406C MARINE ENGINE Fuel Ratio Control
3406C MARINE ENGINE Fuel Injection Lines
3406C MARINE ENGINE Fuel Injection Line Adapters