Electric Starting Motor
Usage:
Remove & Install Electric Starting Motor
1. Disconnect the wires from the starting motor. Put identification on the wires for correct installation.
2. Fasten a hoist to the starting motor, and remove three bolts (1) that hold the starting motor to the flywheel housing. Remove the starting motor. The weight of the starting motor is 32 kg (70 lb).
NOTE: The following steps are for installation of the starting motor.
3. Use a hoist, and put the starting motor in position on the flywheel housing, and install three bolts (1).
4. Install wires in the correct location on the starting motor.
Caterpillar Information System:
3406C MARINE ENGINE Tachometer Drive
3406C MARINE ENGINE Service Meter
3406C MARINE ENGINE Instrument Panel
3406C MARINE ENGINE Engine Rear Support
3406C MARINE ENGINE Engine Front Support
3406C MARINE ENGINE Crankshaft Vibration Damper & Pulley
3406C MARINE ENGINE Air Cleaner
3406C MARINE ENGINE Dipstick Assembly
3406C MARINE ENGINE Engine Lifting Brackets
3406C MARINE ENGINE Introduction
3408C & 3412C INDUSTRIAL ENGINES Testing & Adjusting
3408C & 3412C INDUSTRIAL ENGINES Systems Operation
3406C MARINE ENGINE Sump Pump
3406C MARINE ENGINE Fuel Priming Pump
3406C MARINE ENGINE Fuel Filter Base
3406C MARINE ENGINE Raw Water Pump
3406C MARINE ENGINE Accessory Drive
3406C MARINE ENGINE Fuel Transfer Pump
3406C MARINE ENGINE Fuel Injection Pump & Governor Drive
3406C MARINE ENGINE Governor & Fuel Pump Drive
3406C MARINE ENGINE Fuel Ratio Control
3406C MARINE ENGINE Fuel Injection Lines
3406C MARINE ENGINE Fuel Injection Line Adapters
3406C MARINE ENGINE Fuel Injection Pump & Governor