941 & 951 TRACK TYPE LOADERS Caterpillar

Place speed selector in low gear when going down a steep grade.

Do not downshift or put transmission in NEUTRAL.

Apply brakes to slow machine if engine overspeeds on downgrade. Center pedal on pedal steer, or both pedals on lever steer machine.

Pedal Steer (Normal)

1. Gradual right turn - depress right pedal to release right steering clutch.

2. Sharp right turn - depress right pedal all the way to apply right steering brake.

3. Gradual left turn - depress left pedal to release left steering clutch.

4. Sharp left turn - depress left pedal all the way to apply left steering brake.

Pedal Steer (Steep Downgrade)

1. Gradual right turn - depress left pedal only enough to release left clutch.

2. Sharp right turn - depress right pedal far enough to apply right brake.

3. Gradual left turn - depress right pedal only enough to release right clutch.

4. Sharp left turn - depress left pedal far enough to apply left brake.

Lever Steer (Normal)

1. Gradual right turn - pull right lever back to release right steering clutch.

2. Sharp right turn - pull right lever back and depress right pedal to apply right brake.

3. Gradual left turn - pull left lever back to release left steering clutch.

4. Sharp left turn - pull left lever back and depress left pedal to apply left brake.

Lever Steer (Steep Downgrade)

1. Gradual right turn - pull left lever back to release left clutch - do not apply brake.

2. Sharp right turn - pull right lever back to release right clutch and apply right brake.

3. Gradual left turn - pull right lever back to release right clutch - do not apply brake.

4. Sharp left turn - pull left lever back to release left clutch and apply left brake.

Bucket Lift Control

1. Raise bucket by moving left (inside) control lever back. Control will return to HOLD when bucket reaches limit of travel.

2. Hold bucket in any position by allowing lever to return to HOLD position.

3. Lower bucket by pushing lever forward.

4. Float bucket by pushing lever forward through LOWER into FLOAT position.

Bucket Tilt Control

1. Tilt bucket forward by pulling right (outside) control lever back.

2. Hold bucket in any position by allowing lever to return to HOLD position.

3. Tilt bucket back by pushing lever forward.

Multi-purpose Bucket Control

1. Open bowl by pulling lever back.

2. Hold bowl in any position by returning lever to HOLD.

3. Close bowl by pushing lever forward.

Lifting or tilting of multi-purpose bucket is accomplished with standard bucket controls (see pages 23 and 24).

Ripper Control

1. Raise ripper by pulling control lever back.

2. Hold ripper in any position by returning lever to HOLD.

3. Lower ripper by pushing lever forward.