Usage:
1. Shut off gas supply line to gas pressure regulator.
2. Loosen clamps (1) and slide hose away from the carburetor.
3. Disconnect control rod (2) from the carburetor lever.
4. Remove clamp (3) from the joint assembly.
5. Remove bolts (4) and remove carburetor (5) and gasket from the aftercooler housing.
Install Carburetor (3306)
1. Put a new gasket and carburetor (1) in position and fasten to the aftercooler housing.
2. Slide hose (3) into position on the carburetor and tighten clamps (2).
3. Connect the joint assembly to the carburetor with clamp (5), bolt and nut. Tighten nut to a torque of 49 ± 4 lb.in. (5.5 ± 0.5 N·m).
4. Fasten control rod (4) to the lever on the carburetor.
5. Check the linkage adjustment. See GOVERNOR LINKAGE ADJUSTMENT in TESTING AND ADJUSTING.
6. Turn on gas supply line to gas pressure regulator.