Usage:
1. Drain the coolant from the cooling system.
2. Remove bolts (1).
3. Remove the water hose from the bottom of the water pump.
4. Loosen the water hose clamps from water pipe (2).
5. Remove two bolts (3) and remove the water pump and elbow as a unit.
Install Water Pump
1. Inspect all O-rings, gaskets and hoses and install new parts if needed.
2. Put the water pump and elbow in position and install the bolts.
3. Install the water hose and tighten all water hose clamps.
4. Fill the cooling system to the correct level.
Disassemble Water Pump
start by:
a) remove water pump
1. Remove cover (3) and gasket from water pump (1).
2. Remove elbow (2) and gasket from water pump (1).
3. Loosen bolt (5) .25 in. (6.35 mm). Hit (tap) the bolt with a soft hammer to remove impeller (4) from the shaft.
4. Remove spring and seal assembly (7) from shaft (6).
5. Turn the water pump over and remove bolt (8) and lockwasher.
6. Remove O-ring seal (9) from the housing.
7. Use tooling (A) to remove gear (11) and bearing (10) from the water pump.
8. Remove bearing (10) from gear (11).
9. Remove snap ring (12) with tool (B).
10. Remove bearing (14) and shaft (13) as a unit.
11. Use tool (C) and a press to remove bearing (14) from the shaft.
12. Remove the ceramic ring and seal (15) from the housing.
13. Remove the lip type seal (16) from the housing with tooling (D).
Assemble Water Pump
NOTE: The seal must be installed with the lip toward the bearings.
1. Install the lip type seal in housing (1) with tooling (A) to the bottom of the seal counterbore. Put a thin layer of engine oil on the lip of the seal.
2. Use a press to install shaft (2) in bearing (3).
3. Install the shaft and bearing (3) in housing (1).
4. Install snap ring (4) in the housing with tool (B).
5. Install bearing (5) on gear (6).
| NOTICE |
|---|
When gear (6) is installed, make sure the pins on the gear engage the holes in the shaft. |
6. Put gear (6) and bearing in position on the shaft and install washer and bolt.
7. Install O-ring seal (7) on the housing.
| NOTICE |
|---|
Clean water only is permitted for use as a lubricant to make assembly easier. Do not damage or put hands on the wear surface of the carbon ring or the ceramic ring. Install the ceramic ring with the smoothest face of the ring toward the carbon seal assembly. |
8. Put the ceramic ring (8) in position in the rubber seal. Use hand pressure and tool (which is with the replacement ring) to install the ceramic ring and rubber seal.
9. Remove the spring from the seal assembly (9). Use hand pressure and the tool (which is with the replacement ring) to install the seal assembly. Push seal assembly on the shaft until seal faces make light contact.
10. Install spring (10) on the seal assembly.
11. Put impeller (11) in position on the shaft.
12. Install washer and bolt (12). Tighten the bolt to a torque of 28 ± 1 lb.ft. (39 ± 1 N·m).
13. Install a new gasket and cover (13) on the housing.
14. Install a new gasket and elbow (14) on the housing.
end by:
a) install water pump