Crankshaft Position Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Inspect all O-rings, gaskets, and seals for wear and damage. Replace if necessary.
- Disconnect harness assembly (3).
- Remove mounting hardware (1) and crankshaft position sensor (3).
Show/hide table
| |
| Illustration 1 | g06376143 |
- Install crankshaft position sensor (3) in reverse order of removal.
Caterpillar Information System:
120 and 120 AWD Motor Grader Transmission and Differential Oil Sample - Obtain
XQ570 Rental Generator Set Setup
120 and 120 AWD Motor Grader Belts - Inspect/Adjust/Replace
120 and 120 AWD Motor Grader Transmission and Differential Oil Level - Check
120 and 120 AWD Motor Grader Transmission and Differential Oil Filter and Screens - Replace/Clean
794 AC Off-Highway Truck Engine Components - Clean/Inspect, Rebuild/Install Reman, Install New
794 AC Off-Highway Truck Exhaust Outlet Nitrogen Oxide Sensor - Replace
794 AC Off-Highway Truck Exhaust Inlet Nitrogen Oxide Sensor - Replace
794 AC Off-Highway Truck Breather Line (Diesel Exhaust Fluid) - Inspect
C27 and C32 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
794 AC Off-Highway Truck Breather (DEF Tank) - Replace
C175 Tier 4 Final Engines for Caterpillar Built Machines Water Pump - Remove and Install
120 and 120 AWD Motor Grader Fuel System Water Separator - Drain
336, and 340 Excavator TA2 Technical Inspection {0372, 0374, 1000, 7000, 753T, 7565} 336, and 340 Excavator TA2 Technical Inspection {0372, 0374, 1000, 7000, 753T, 7565}
120 and 120 AWD Motor Grader Declaration of Conformity
120 Motor Grader Monitoring System Display Module
Improved Circuit Breaker Bus Bars are Now Used on Certain C32, C175, 3500, and G3500 Generator Sets {1420, 445B} Improved Circuit Breaker Bus Bars are Now Used on Certain C32, C175, 3500, and G3500 Generator Sets {1420, 445B}
Improved Dust Seal for the Swing Gear and Bearing is Now Available on Certain Excavators {7063} Improved Dust Seal for the Swing Gear and Bearing is Now Available on Certain Excavators {7063}
3500E Marine Engines Engine Oil Level - Check
C27 and C32 Generator Set Engines Coolant Temperature Sensor - Remove and Install
High Soot Loading on Certain C7.1 Engines {1000, 108D} High Soot Loading on Certain C7.1 Engines {1000, 108D}
120 Motor Grader Monitoring System Menus
308 Mini Hydraulic Excavators Daily Inspection
C175-16 Generator Set Filter Screen (Air) - Clean/Replace