Issues With the Wiring of the Generator Space Heater on Certain Flex Generator Packages {7274}
- Generator Set
- C32 GEN SET (S/N: NRC273-274,309-310,312-336,341-343,345-357,359-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Generator space heater group may be wired incorrectly in 240 V parallel instead of 120 V series connection on the above mentioned generator set packages.
Solution
Caterpillar is aware of this problem, but a permanent repair has not been identified. As an interim action, execute the following rework procedure to ensure the correct wiring (120 V series operation) to the 486-4557 Space Heater Gp.
Rework Instructions:
- Remove the control panel on the left side by removing eight M6 bolts, two M6 nuts, and washer using 8 mm socket.
- Lift the cover upwards, pull out the bottom and slide off the top two studs.
Show/hide table
Illustration 2 g06062483 (1) Jumper - Remove the orange jumper from HTR L1 to HTR H3 and orange jumper from HTR H4 to HTR L2.
- Place one orange jumper in HTR H3 to HTR H4. Ensure that the jumper is fully seated on the position. Refer to Illustration 2 for proper orange jumper position.
- Discard the other orange jumper.
- Place the control panel cover to the original position and reinstall the 8 mm bolts, nut, and washer.
Show/hide table
Illustration 1 | g06062470 |
This graphic is shown with the panel removed. |
Caterpillar Information System:
XQ60 Rental Generator Set Maintenance Interval Schedule
3512E Engines Pistons and Connecting Rods - Remove and Install
352F Excavator Engine Oil and Filter - Change
3512E Land Electric Drive Fuel System Secondary Filter - Replace
352F OEM Excavator Based Specialty Solutions Joystick Controls Alternate Patterns
323F SA and 323F LN Excavator and 323F LN MHPU Machine Systems Specifications Coolant Tank and Mounting
C7.1 Commercial Marine Engine ECM Software - Install
C12.9 Marine Engines Camshaft - Remove and Install
C7.1 Commercial Marine Engine Solenoid Valve - Test
C7.1 Marine Engine Fuel Transfer Pump - Test
C7.1 Commercial Marine Engine Sensor Supply - Test
C7.1 Commercial Marine Engine Relay - Test - Start Relay
3512E Engines Crankshaft - Remove and Install
3512E HD Petroleum Engine Engine Air Cleaner Differential Pressure - Check
797 Off-Highway Truck Suspension Mounting (Front) - Check
3512E HD Petroleum Engine Overhaul Considerations
3516C Generator Set Engines Aftercooler - Remove and Install
320 GC, 320 and 323 Excavator Access Door and Cover Locations
3512E HD Petroleum Engine Fuel System Primary Filter/Water Separator - Drain
3512E Engines Check Valve (Fuel) - Remove and Install - Injector Back Pressure Regulator
C9.3 Marine Auxiliary Engines Monitoring System
XQ60 Rental Generator Set Cooling System Coolant Sample (Level 1) - Obtain
XQ60 Rental Generator Set Cooling System Coolant Sample (Level 2) - Obtain
C12.9 Marine Engines Belt Tensioner - Remove and Install - Supercharger Drive Belt Tensioner