Engine Oil Filter
Show/hide table
| |
| Illustration 1 | g03785222 |
|
Typical example | |
- Before the engine oil filter is installed, place a thin film of clean engine oil on the face of the seal.
- Tighten the engine oil filter by hand until the seal contacts the mounting face of the cylinder block.
- Tighten the engine oil filter by hand according to the instructions that are shown on the filter. Do not overtighten the engine oil filter.
Caterpillar Information System:
C2.2 Engines for Caterpillar Built Machines Engine Oil Lines
C13 Generator Set Engine Voltage Regulator - Remove and Install
C4.4 and C6.6 Engines Cooling Fan Speed - Test
C2.2 Engines for Caterpillar Built Machines Engine Oil Relief Valve
C2.2 Engines for Caterpillar Built Machines Cylinder Head Valves
C7.1 Engines Cooling Fan Reversing - Test - Hydraulic Driven Fan
C13 Generator Set Engine Battery Charger - Remove and Install
2015/01/23 New Coupling Bolts and Couplings Are Used On Certain 3512C Engines {3252}
F Series Excavator Monitoring System Prestart Monitoring Function - If Equipped
C2.2 Engines for Caterpillar Built Machines Camshaft
C2.2 Engines for Caterpillar Built Machines Water Temperature Regulator
C4.4 Engines Cooling Fan Control - Test - Hydraulic Driven Fan
C7.1 Engines Data Link - Test
C13 Generator Set Engine Air Control Valve - Remove and Install
C13 Generator Set Engine Flywheel - Remove and Install
C13 Generator Set Engine Vibration Damper and Pulley - Remove and Install
2015/01/16 Cat® Reman Announces the Availability of Remanufactured Engines for Certain Electric Power Generation Applications {1000}
C13 Generator Set Engine Alternator - Remove and Install
C7.1 Engines Data Link Configuration Status - Test
C7.1 Engines DEF Control Module Power - Test
794 AC Off-Highway Truck Engine Supplement Hood - Remove and Install
C2.2 Engines for Caterpillar Built Machines Belt Tension Chart
C2.2 Engines for Caterpillar Built Machines Temperature Sensor (DOC Inlet)
C7.1 Engines DEF Line Heater - Test