Control System - Remove and Install - M.C.S. Panel
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- The engine can start automatically. Ensure that the power supply is isolated before any service or repairs is performed.
- Turn the battery disconnect switch to the OFF position.
Show/hide table
Illustration 1 g03343495 - Disconnect harness assemblies (1).
Show/hide table
Illustration 2 g03343496 - Remove bolts (2) and remove cover (3).
Show/hide table
Illustration 3 g03343497 Note: Label harness assemblies (4) for reinstallation.
- Disconnect harness assemblies (4). Route harness assembly (4) through opening as indicated in Illustration 3.
Show/hide table
Illustration 4 g03343503 - Remove nuts (5). The weight of control system (6) is approximately
40 kg (88 lb) . Use two people to remove control system (6).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install control system (6) in the reverse order of removal.
- Tighten nuts (5) to a torque of
44 N·m (33 lb ft) .
- Tighten nuts (5) to a torque of
Caterpillar Information System:
C7.1 Industrial Engine Plate Locations and Film Locations
C7.1 Marine Engine Electric Starting Motor - Remove and Install
C7.1 Marine Engine Jacket Water Heater - Remove and Install
C7.1 Marine Engine Air Cleaner Housing - Remove and Install
C7.1 Marine Engine Engine Oil Relief Valve - Remove and Install
C7.1 Marine Engine Inlet and Exhaust Valves - Remove and Install
C7.1 Marine Engine Inlet and Exhaust Valve Springs - Remove and Install
C7.1 Marine Engine Camshaft Gear - Remove and Install
C7.1 Marine Engine Camshaft - Remove and Install
C7.1 Marine Engine Lifter Group - Remove and Install
C7.1 Marine Engine Bearing Clearance - Check
C7.1 Marine Engine Crankshaft Gear - Remove and Install
C15 and C18 Engines Product Storage
C7.1 Industrial Engine Reference Information
C7.1 Industrial Engine Emissions Certification Film
2013/02/20 A New Water Temperature Regulator Housing Is Now Available for Certain C15 and C18 Industrial Engines {1355, 1393}
3516C Petroleum Well Service Engine Model View Illustrations
3516C Petroleum Well Service Engine Safety Messages
C32 Marine Generator Set Starting the Engine
TA2 Inspection for C18 Marine Auxiliary Engines{1000} TA2 Inspection for C18 Marine Auxiliary Engines{1000}
3516C Petroleum Well Service Engine Product Lifting
3516C Petroleum Well Service Engine Coolant (DEAC) - Change
C7.1 Marine Engine Turbocharger - Remove and Install
3516C Petroleum Well Service Engine Coolant (ELC) - Change