Electric Starting Motor - Remove and Install
Show/hide table
Accidental engine starting can cause injury or death to personnel working on the equipment. To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system. Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on. |
- The engine can start automatically. Ensure that the power supply is isolated before any service or repairs is performed.
- Turn the battery disconnect switch to the OFF position.
- Place identification marks on the harness assembly that is connected to the electric starting motor and the solenoid.
Show/hide table
Illustration 1 g01530455 Typical example - Disconnect the harness assembly from electric starting motor (3) and the solenoid.
- Remove bolts (2) for electric starting motor (3).
- Remove electric starting motor (3).
- Install electronic starting motor (3) in the reverse order of removal.
- Tighten bolts (2) to a torque of
44 N·m (32 lb ft) .
- Tighten bolts (2) to a torque of
Caterpillar Information System:
C7.1 Marine Engine Jacket Water Heater - Remove and Install
C7.1 Marine Engine Air Cleaner Housing - Remove and Install
C7.1 Marine Engine Engine Oil Relief Valve - Remove and Install
C7.1 Marine Engine Inlet and Exhaust Valves - Remove and Install
C7.1 Marine Engine Inlet and Exhaust Valve Springs - Remove and Install
C7.1 Marine Engine Camshaft Gear - Remove and Install
C7.1 Marine Engine Camshaft - Remove and Install
C7.1 Marine Engine Lifter Group - Remove and Install
C7.1 Marine Engine Bearing Clearance - Check
C7.1 Marine Engine Crankshaft Gear - Remove and Install
C7.1 Marine Engine Crankshaft Timing Ring - Remove and Install
C7.1 Marine Engine Crankshaft Main Bearings - Remove and Install - Crankshaft in position
C7.1 Industrial Engine Plate Locations and Film Locations
C7.1 Marine Engine Control System - Remove and Install - M.C.S. Panel
C15 and C18 Engines Product Storage
C7.1 Industrial Engine Reference Information
C7.1 Industrial Engine Emissions Certification Film
2013/02/20 A New Water Temperature Regulator Housing Is Now Available for Certain C15 and C18 Industrial Engines {1355, 1393}
3516C Petroleum Well Service Engine Model View Illustrations
3516C Petroleum Well Service Engine Safety Messages
C32 Marine Generator Set Starting the Engine
TA2 Inspection for C18 Marine Auxiliary Engines{1000} TA2 Inspection for C18 Marine Auxiliary Engines{1000}
3516C Petroleum Well Service Engine Product Lifting
3516C Petroleum Well Service Engine Coolant (DEAC) - Change