| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Loosen the hose clamp and disconnect hose assembly from air outlet (5) from turbocharger (4).
- Disconnect hose assembly (2) from the wastegate actuator.
- Remove bolt (8) from the clip for the tube assembly. Disconnect hose assembly (7) from the connection in the outlet of turbocharger (4).
- Loosen the allen head bolt on V-band clamp (3) and V-band clamp (9) from elbow (1). Remove the V-band clamps from the elbow.
Note: If V-band clamp (3) and V-band clamp (9) remain tight on the flanges, apply releasing fluid on the V-band clamps. Lightly tap the bolts on the V-band clamps with a soft faced hammer in order to assist removal. Do not use a prybar in order to remove V-band clamps.
- Remove elbow (1) from turbocharger (4) and turbocharger (10).
Note: Plug the open ports of the turbochargers.
- Loosen allen head bolt on V-band clamp (6) for air duct (13).
- Loosen hose clamp (11).
- Remove hose assembly (12), and V-band clamp (6), air duct (13) as an assembly from the outlet of turbocharger (10) and turbocharger (4).
Note: Plug the open ports of the turbochargers.
Show/hide table
Illustration 2 g02175962 - Remove banjo bolt (14) from tube assembly (15) for the oil feed for turbocharger (4).
Note: Plug the port for the oil feed in the turbocharger and plug the tube assembly.
- Remove sealing washers (16).
- Remove bolts (18) from tube assembly (19).
- Disconnect tube assembly (19) from turbocharger (4) and remove gasket (17) (not shown).
Note: Plug the drain tube assembly for the turbocharger. Plug the port on the turbocharger.
Show/hide table
Illustration 3 g02175963 - Remove nuts (21) from turbocharger (4).
Note: Ensure that the weight of the turbocharger is supported as the nuts are removed.
- Remove turbocharger (4) from exhaust manifold (20).
- Remove gasket (22).
- If necessary, remove studs (23) from turbocharger (4).
| |
| Illustration 1 | g02175961 |
