Air Starting Motor - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- If necessary, install the solenoid for the air starting motor to the generator base. Follow Step 1.a through Step 1.c in order to install the solenoid.
- Position solenoid (6) onto the generator base and install nuts and bolts (9). Tighten the nuts and bolts to a torque of
9 N·m (80 lb in) . - Connect plastic tube assembly (7) and plastic tube assembly (8) from solenoid (6). Tighten the connections for plastic tube assemblies securely.
- Connect harness assembly (10).
- Position solenoid (6) onto the generator base and install nuts and bolts (9). Tighten the nuts and bolts to a torque of
- Position air starting motor (3) onto flywheel housing (3). Support the weight of the air starting motor (1) and install bolts (2). Tighten the nuts and bolts to a torque of
44 N·m (33 lb ft) . - Connect plastic tube assembly (3) and plastic tube assembly (4) to air starting motor (1). Tighten the connections for plastic tube assemblies securely.
- Connect hose assembly (5) to the air starting motors (1). Tighten the connection for the hose assembly securely.
- Turn the battery disconnect switch to the ON position.
- Turn the air supply at the air reservoir to the ON position.
Show/hide table
Illustration 1 | g01530473 |
Caterpillar Information System:
C6.6 Marine Generator Set Air Starting Motor - Remove
C6.6 Marine Generator Set Electric Starting Motor - Remove and Install
C6.6 Marine Generator Set Alternator - Remove and Install
C6.6 Marine Generator Set Electronic Control Module - Remove and Install
C6.6 Marine Generator Set V-Belts - Remove and Install
C6.6 Marine Generator Set Glow Plugs - Remove and Install
C6.6 Marine Generator Set Inlet Air Temperature Sensor - Remove and Install
C6.6 Marine Generator Set Boost Pressure Sensor - Remove and Install
C6.6 Marine Generator Set Engine Speed Sensor - Remove and Install - Overspeed Sensor
C6.6 Marine Generator Set Fuel Pressure Sensor - Remove and Install
C6.6 Marine Generator Set Engine Oil Pressure Sensor - Remove and Install
C6.6 Marine Generator Set Coolant Temperature Sensor - Remove and Install
CX28 On-Highway Transmission Oil Filter (Transmission)
A New Remanufactured Cylinder Pack, Oil Cooling Jet, and Engine Oil Pump are Now Used{1214, 1304, 1331} A New Remanufactured Cylinder Pack, Oil Cooling Jet, and Engine Oil Pump are Now Used{1214, 1304, 1331}
793F and 793F CMD Off-Highway Truck Air System Air Compressor Governor
793F and 793F CMD Off-Highway Truck Air System Relief Valve (Air Tank)
793F and 793F CMD Off-Highway Truck Air System Regulator (Automatic Lubrication)
3508B, 3512B, and 3516B High Displacement Generator Sets Engine Oil and Filter - Change
2008/06/09 Shutdown the Jacket Water Heater During Generator Set Operation {1383}
C-15, C-16, and C-18 Truck Engines Water Temperature Regulator
Air Conditioning and Heating R134a for All Caterpillar Machines General Information
793F and 793F CMD Off-Highway Truck Air System Visual Inspection
793F and 793F CMD Off-Highway Truck Air System Air System Troubleshooting
793F and 793F CMD Off-Highway Truck Air System Air Compressor Governor - Test and Adjust