Water Pump - Remove
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 138-7573 | Link Bracket | 1 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
- Disconnect water inlet connection (1) from water pump (3) .
Show/hide table
 | |
| Illustration 1 | g00544018 |
Show/hide table
 | |
| Illustration 2 | g00544019 |
- Remove bolts (2) .
- Remove bolts (6) .
- Remove elbow (4), tube (7), and elbow (8) as a unit. Check the gaskets and the O-ring seal for wear or damage. If necessary, replace the gaskets.
- Attach Tooling (A) and a suitable lifting device to water pump (3). The weight of water pump (3) is approximately 68 kg (150 lb). Remove bolts (5) that hold water pump (3) to the front housing. Remove water pump (3) .
- Remove the O-ring seal from water pump (3). Check the O-ring seal for wear or damage. If necessary, replace the O-ring seal.
Caterpillar Information System:
3608 Engine Cylinder Liner - Install
3176C, 3406E and 3456 Industrial Engines Component Location
G3520B Engine Prelube Pump - Inspect
C32 Marine Engine Cold Start Strategy
3176C, 3406E and 3456 Industrial Engines System Overview
C4.4 Industrial Engine Exhaust Manifold - Inspect
G3520B Engine Product Lifting
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Engine Rating Definitions
3508B, 3512B, 3516B, 3512C and and 3516C Auxiliary Engines, Generator Set Engines, and Generator Sets Gauges and Indicators
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Gauges and Indicators
2007/11/05 Replacement of the Priming Pump {1258}
2007/10/22 The 6V-6146 Load Leveler Handles Large Components Up To 4500 kg (10,000 lb) {0632, 0635, 1000, 7000}
3608 Engine Water Pump - Install
2008/11/01 New Lines and Clamps are Now Used for the Air Control Group {1087, 7554}
3608 Engine Auxiliary Water Pump - Assemble
3608 Engine Water Pump Seal - Remove
3608 Engine Water Pump Seal - Install
3608 Engine Fuel Pressure Control Valve - Assemble
3608 Engine Fuel Pressure Control Valve - Install
3608 Engine Prelubrication Oil Pump - Remove
3608 Engine Prelubrication Oil Pump - Install
3608 Engine Camshaft Bearings - Install
3176C, 3406E and 3456 Industrial Engines Indicator Lamps
C32 Marine Generator Set Engine Oil and Filter - Change