Inlet Manifold Temperature Sensor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1). Remove inlet manifold temperature sensor (2) .
Show/hide table
Illustration 1 | g01294090 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install inlet manifold temperature sensor (2). Tighten inlet manifold temperature sensor (2) to a torque of 20 ± 5 N·m (15 ± 4 lb ft). Connect harness assembly (1) .
Show/hide table
Illustration 2 | g01294090 |
Caterpillar Information System:
3516C Locomotive Engine Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
C15 On-Highway Engine Engine Control Module - Remove and Install
C15 On-Highway Engine Air Compressor - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys K1 Overcurrent Shutdown - Reset
C175-16 and C175-20 Engines for Off-Highway Trucks Air Starting System
12M Motor Grader Daily Inspection
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Speed Sensor (Transmission) - Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Speed Sensor (Transmission) - Remove
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission and Torque Converter - Connect
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission and Torque Converter - Separate
C15 and C18 Petrolem Generator Set Engines ECM Does Not Communicate with Other Modules
C13 and C15 On-highway Engines Engine Running - Test
C15 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C15 On-Highway Engine Boost Pressure Sensor - Remove and Install
3500C Marine Auxiliary Engines Factory Passwords
C15 On-Highway Engine Fuel Pressure Sensor - Remove and Install - ARD Pilot Fuel Pressure Sensor
C15 On-Highway Engine Fuel Pressure Sensor - Remove and Install - ARD Main Fuel Pressure Sensor
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Silicon Controlled Rectifiers - Test
C15 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
C27 and C32 Generator Set Engines Aftercooler - Remove
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Emergency Power Off - Reset
C15 On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install
2006/08/07 Marine Engines are Shipped Without Oil {1348}
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Log File - Retrieve