Engine Control Module - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the negative battery terminal at the battery.
- Loosen allen head screw (1). Disconnect harness assembly (2) from engine control module (4) .
Show/hide table
Illustration 1 | g01294081 |
- Remove studs (3). Remove engine control module (4), the washers, and the isolation mounts.
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the isolation mounts, spacers, electronic control module (4) and the ground strap. Install studs (3) .
Show/hide table
Illustration 2 | g01294081 |
- Connect harness assembly (2) to engine control module (4) and tighten allen head screw (1) .
- Connect the negative battery terminal at the battery.
Caterpillar Information System:
C15 On-Highway Engine Air Compressor - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys K1 Overcurrent Shutdown - Reset
C175-16 and C175-20 Engines for Off-Highway Trucks Air Starting System
12M Motor Grader Daily Inspection
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Speed Sensor (Transmission) - Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Speed Sensor (Transmission) - Remove
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission and Torque Converter - Connect
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission and Torque Converter - Separate
C15 and C18 Petrolem Generator Set Engines ECM Does Not Communicate with Other Modules
C13 and C15 On-highway Engines Engine Running - Test
C175-16 Locomotive Engine Camshaft
C7 and C9 On-Highway Engines Electrical Connectors
3516C Locomotive Engine Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
C15 On-Highway Engine Inlet Manifold Temperature Sensor - Remove and Install
C15 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C15 On-Highway Engine Boost Pressure Sensor - Remove and Install
3500C Marine Auxiliary Engines Factory Passwords
C15 On-Highway Engine Fuel Pressure Sensor - Remove and Install - ARD Pilot Fuel Pressure Sensor
C15 On-Highway Engine Fuel Pressure Sensor - Remove and Install - ARD Main Fuel Pressure Sensor
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Silicon Controlled Rectifiers - Test
C15 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
C27 and C32 Generator Set Engines Aftercooler - Remove
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Emergency Power Off - Reset
C15 On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install