Crankshaft Rear Seal - Remove
Start By:
- Remove the flywheel. Refer to this Disassembly and Assembly Manual, "Flywheel - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Remove the setscrews (1) from the assembly of the crankshaft rear seal (2).
- Remove the assembly of the crankshaft rear seal (2) from the cylinder block. Discard the assembly of the crankshaft rear seal (2).
Show/hide table
Illustration 1 | g00991388 |
Note: The assembly of the crankshaft rear seal (2) is nonserviceable. If the assembly of the crankshaft rear seal (2) is removed, the assembly must be replaced.
Caterpillar Information System:
G3500 A3 Engines Engine Overload
G3500 A3 Engines Engine Overcrank
C9 Industrial Engines Coolant Temperature Sensor
C7 PETROLEUM Petroleum Engine Turbocharger - Install
3500B and 3500C Locomotive Engines Air Shutoff System
C7 PETROLEUM Petroleum Engine Turbocharger - Remove
C15 Industrial Engine Idle Shutdown Timer - Test
C3.3 and C4.4 Generator Sets Valve Mechanism Cover - Remove and Install - Four Cylinder Engines
G3500 Engines After Starting Engine
C3.3 and C4.4 Generator Sets Crankcase Breather - Remove and Install
G3500 Engines Starting with Jump Start Cables
G3500 Engines Water Temperature Regulator - Replace
C3.3 Industrial Engine Crankshaft Rear Seal - Install
C7 PETROLEUM Petroleum Engine Exhaust Manifold - Remove and Install
C7 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
G3508, G3512 and G3516 Engines Crankshaft - Remove
C280 Marine Auxiliary Engines Self-Diagnostics
C280 Marine Propulsion Engines Intermittent Engine Shutdown
Air Conditioning and Heating R134a for All Caterpillar Machines Identifying the Air Conditioning System
C7 PETROLEUM Petroleum Engine Inlet and Exhaust Valve Springs - Remove and Install
C13 and C15 On-Highway Engines Emissions Certification Film
C7 PETROLEUM Petroleum Engine Inlet and Exhaust Valves - Remove and Install
G3508, G3512 and G3516 Engines Crankshaft - Install
AccuGrade® GPS (CD700) Flashing Messages