Turbocharger - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 5P-3931     | 防粘结剂     | 1     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 在排气歧管的涡轮增压器安装双头螺栓上涂抹工具 (A) 。
- 涡轮增压器 (1) 的重量约为 17 kg (38 lb)。 在排气歧管上定位密封垫和涡轮增压器 (1) 。
Show/hide table
图 1 | g01256325 |
- 安装螺母 (5) 。 拧紧螺母 (5) 至扭矩为 54 ± 5 N·m (40 ± 4 lb ft)。
- 安置管组件 (3) 并安装螺栓 (4) 。
- 连接软管组件 (2) 。
Caterpillar Information System:
3500B and 3500C Locomotive Engines Air Shutoff System
C7 PETROLEUM Petroleum Engine Turbocharger - Remove
C15 Industrial Engine Idle Shutdown Timer - Test
C3.3 and C4.4 Generator Sets Valve Mechanism Cover - Remove and Install - Four Cylinder Engines
G3500 Engines After Starting Engine
C3.3 and C4.4 Generator Sets Crankcase Breather - Remove and Install
G3500 Engines Starting with Jump Start Cables
G3500 Engines Water Temperature Regulator - Replace
C3.3 and C4.4 Generator Sets Fuel Injection Lines - Remove and Install
C3.3 and C4.4 Generator Sets Fuel Priming Pump and Fuel Filter Base - Remove and Install
G3500 Engines Actuator Control Linkage - Lubricate
C7 PETROLEUM Petroleum Engine Electronic Unit Injector - Install
C9 Industrial Engines Coolant Temperature Sensor
G3500 A3 Engines Engine Overcrank
G3500 A3 Engines Engine Overload
C3.3 Industrial Engine Crankshaft Rear Seal - Remove
C3.3 Industrial Engine Crankshaft Rear Seal - Install
C7 PETROLEUM Petroleum Engine Exhaust Manifold - Remove and Install
C7 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
G3508, G3512 and G3516 Engines Crankshaft - Remove
C280 Marine Auxiliary Engines Self-Diagnostics
C280 Marine Propulsion Engines Intermittent Engine Shutdown
Air Conditioning and Heating R134a for All Caterpillar Machines Identifying the Air Conditioning System
C7 PETROLEUM Petroleum Engine Inlet and Exhaust Valve Springs - Remove and Install