Remanufactured Clutch Plates Available For Power Shift Transmissions{3155,0375}
Usage:
Remanufactured clutch plates are available for Caterpillar power shift transmissions. The quality, expected service life, and warranty for these clutch plates are the same as new plates, but the cost is much lower. For this reason, the use of remanufactured clutch plates will lower the cost of transmission reconditioning and the customer's cost of operation.
The chart shows the form numbers of Technical Parts-grams and Guidelines For Reusable Parts which will be of assistance in the use of remanufactured clutch plates. These forms can be ordered for use as reference material.
Caterpillar Information System:
1981/06/08 Troubleshooting Water In Shut-Off Solenoid Housing{1259}
1981/06/08 Inspect Piston Skirts During Engine Overhaul Procedures{1214,1213}
1981/06/01 Hardened Nuts And Higher Torque Now Used In Ahead And Astern Clutch Groups{3302}
1981/06/01 New Service Meter Used In Mechanical Shutoff Group{7478}
1981/06/01 Some Single Part Numbers Have Two Half Bearings{7551}
1981/06/01 New Seals And Clutch Discs Used{3300,3302}
1981/06/01 Correct Use Of Keystone Ring Groove Gauges{1214,1215,1312,0653}
1981/06/01 Locks No Longer Used On Flywheel Bolts; New Torque Specifications For Flywheel Bolts{1156}
1981/05/25 Air System Leakage Can Cause Problems With Engine Governor Stability At Low Idle RPM{1264,1803}
1981/05/25 New Cover Assembly And Gasket Used In Oil Pump Group{7418}
1981/05/25 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear{1206}
1981/05/25 Use Correct Specifications To Check Piston Ring Gaps{1215}
1981/06/15 Procedure To Stop Lubricant Leakage From Flexible Couplings{3252}
1981/06/15 Plastic Cases Now Available For Electronic Testing And Diagnostic Equipment{0630,0650}
1981/06/22 6V3145 Leveler Now Available{0644}
1981/06/22 Cylinder Liners Can Now Be Reconditioned Automatically{0664,0674,1216}
1981/06/22 Larger Air Cleaner Used For Less Restriction To Air Flow{1051}
1981/06/29 Ring Now Used To Hold Bearing In Auxiliary Drive Group{1165}
1981/06/29 New Gasket Used In Front Housing Group{1166,1162,1151}
1981/06/29 New Inlet And Exhaust Valves And Valve Guides Have Tighter Fit To Prevent Corrosion And Guide Wear{1104,1105,1101,1103,1108,1109}
1981/06/29 Use 6V4828 Snap Ring Pliers To Remove Snap Rings From Turbocharger Housing{0610,1052}
1981/06/29 New Gasket Used For End Cover On Inlet Manifold{1058}
1981/06/29 Tube Added To Prevent Air Leakage In Pressure Regulator{3012,3165,3166,3186}
1981/06/29 Some Parts Books And Microfiche Show Wrong Governor And Fuel Pump Drive Groups For Specific Engines{1288,0374}