Valve Covers
Usage:
Remove & Install Valve Covers
Typical Example
1. Loosen clamps (2), and disconnect the hose from the breather cap.
2. Remove the bolts that hold the valve cover to the valve cover base. Remove valve cover (1).
3. Check the condition of the valve cover seal. If necessary, replace the seal.
NOTE: The following steps are for installation of the valve cover.
4. Put a new seal in position in the valve cover, and cut it to length after installation. Apply 4C-9612 Sealant to the joints of the seal.
5. Put valve cover (1) in position on the valve cover base. Install the bolts that hold the valve cover in place. Tighten the bolts to a torque of 18 ± 3 N·m (13 ± 2 lb ft).
6. Connect the hose to the breather cap and tighten two clamps (2).
Caterpillar Information System:
3406C GENERATOR SET ENGINE Fuel Injection Pump Housing
3406C GENERATOR SET ENGINE Fuel Injection Pumps
3406C GENERATOR SET ENGINE Governor
3406C GENERATOR SET ENGINE Fuel Injection Pump Housing & Governor
3406C GENERATOR SET ENGINE Governor & Fuel Pump Drive
3406C GENERATOR SET ENGINE Fuel Transfer Pump
3406C GENERATOR SET ENGINE Fuel Filter & Base
3406C GENERATOR SET ENGINE Fuel Injection Lines
3406C GENERATOR SET ENGINE Radiator & Radiator Guard
3406C GENERATOR SET ENGINE Radiator
3406C GENERATOR SET ENGINE Service Meter
3406C GENERATOR SET ENGINE Engine Design
3406C GENERATOR SET ENGINE Fuel Injection Line Adapters
3406C GENERATOR SET ENGINE Electric Starting Motor
3406C GENERATOR SET ENGINE Turbocharger
3406C GENERATOR SET ENGINE Water Temperature Regulator
3406C GENERATOR SET ENGINE Engine Oil Cooler
3406C GENERATOR SET ENGINE Oil Filter & Base
3406C GENERATOR SET ENGINE Oil Filter Base
3406C GENERATOR SET ENGINE Exhaust Manifold
3406C GENERATOR SET ENGINE Water Pump
3406C GENERATOR SET ENGINE Fan Drive
3406C GENERATOR SET ENGINE Vibration Damper & Pulley
3406C GENERATOR SET ENGINE Engine Front Support