Valve Seat Inserts
Usage:
Remove and Install Valve Seat Inserts
Start By:
a. remove cylinder head
b. remove valves
Typical Example
1. Use Tooling (A) to remove the valve seat inserts from the cylinder head.
2. Clean and remove any burrs from the valve seat bores.
NOTE: Refer to Special Instruction, SEHS9564, "Cylinder Heads-Critical Factors For Reconditioning" for additional information.
NOTE: The following steps are for the installation of the valve seat inserts.
Typical Example
3. Lower the temperature of the new valve seat inserts to -40° C (-40° F). Use Tooling (B), and install new valve seat inserts (1) into the cylinder head. Refer to the Specifications for additional information.
End By:
a. install valves
b. install cylinder head
Caterpillar Information System:
3406E TRUCK ENGINE Valve Seals
3406E TRUCK ENGINE Inlet and Exhaust Valves
3406E TRUCK ENGINE Valve Springs
3406E TRUCK ENGINE Spacer Plate
3406E TRUCK ENGINE Cylinder Head Assembly
3406E TRUCK ENGINE Rocker Arm and Shaft Assemblies
3406E TRUCK ENGINE Valve Cover Base
3406E TRUCK ENGINE Valve Covers
3406E TRUCK ENGINE Pump Drive
3406E TRUCK ENGINE Timing Gears and Plate
3406E TRUCK ENGINE Timing Gear Cover
3406E TRUCK ENGINE Vibration Damper and Pulley
3406E TRUCK ENGINE Valve Guides
3406E TRUCK ENGINE Oil Pan
3406E TRUCK ENGINE Flywheel
3406E TRUCK ENGINE Flywheel Housing
3406E TRUCK ENGINE Oil Pump
3406E TRUCK ENGINE Piston Cooling Jets
3406E TRUCK ENGINE Camshaft
3406E TRUCK ENGINE Camshaft Bearings
3406E TRUCK ENGINE Connecting Rod Bearings
3406E TRUCK ENGINE Crankshaft Main Bearings
3406E TRUCK ENGINE Crankshaft
3406E TRUCK ENGINE Crankshaft Front Seal and Wear Sleeve