Usage:
Start By:
a. remove the cylinder head assembly
1. Remove gasket (2) from spacer plate (1).
2. Remove O-ring seal (3) and water seals (1) from spacer plate (1).
3. Remove spacer plate (1).
4. Remove spacer plate gasket (6) from the cylinder block.
5. Remove O-ring seal (7).
NOTE: The following steps are for installing the spacer plate.
| NOTICE |
|---|
Ensure that the spacer plate and the machined surface of the cylinder block are clean and free of dirt and foreign material. Both surfaces of the spacer plate gasket and the top of the cylinder block must be clean. Do not use a gasket adhesive on these surfaces. |
6. Install new spacer plate gasket (6) over the dowels in the cylinder block.
7. Install O-ring seal (7).
8. Install spacer plate (1), O-ring seal (3) and seals (4).
9. Check the cylinder liner projection. Refer to the System Operation/Testing and Adjusting, "Cylinder Liner Projection" or refer to Special Instruction, SEHS9564, for additional information.
10. Install new cylinder head gasket (2) on the spacer plate.
End By:
a. install cylinder head assembly