Front Cover - Remove
Start By:
- Remove the water temperature regulator housing. Refer to Disassembly and Assembly, "Water Temperature Regulator - Remove and Install".
- Remove the heat exchanger. Refer to Disassembly and Assembly, "Heat Exchanger - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1). Remove bracket assembly (2).
Show/hide table
Illustration 2 g01102134 - Remove bolts (3) and nut (4) from the front of the cover.
Show/hide table
Illustration 3 g01102138 - Remove nut (5) from the stud on front cover (6). Remove front cover (6) and the gasket.
Show/hide table
Illustration 1 | g01102133 |
Caterpillar Information System:
G3408 and G3412 Engines Electrical System
G3606 and G3608 Engines Valve Cover - Remove and Install
G3408 and G3412 Engines Air Starting System
G3408 and G3412 Engines Basic Block
G3606 and G3608 Engines Crankcase Breather - Remove and Install
3412E, C30 and C32 Marine Engines Vibration Damper and Pulley - Remove and Install
Alignment of Two-Bearing Generators{4471} Alignment of Two-Bearing Generators{4471}
3600 Distillate Fuel Engines Engine Power Ratings
Generator Set Control Panel for Switchgear Conversion CID 0100 FMI 08 Pressure Sensor (Engine Oil) Abnormal Signal - Test
G3408 and G3412 Engines Cooling System
G3606 and G3608 Engines Flywheel and Coupling Guards - Remove and Install
3412E, C30 and C32 Marine Engines Flywheel - Install
3412E, C30 and C32 Marine Engines Front Cover - Install
Generator Set Control Panel for Switchgear Conversion CID 0102 FMI 08 Pressure Sensor (Boost) Abnormal Signal - Test
G3606 and G3608 Engines Rocker Arm - Remove
G3606 and G3608 Engines Rocker Arm - Install
Generator Set Control Panel for Switchgear Conversion CID 0110 FMI 08 Temperature Sensor (Engine Coolant) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0172 FMI 04 Temperature Sender (Inlet Air) Voltage Below Normal - Test
Electric Protection System Energize-To-Shutoff (ETS) For Generator Set, Industrial and Marine Diesel Engines Troubleshooting the ETS Partial Protection System (OP, WT) - 3200-3400 Engines
G3606 and G3608 Engines Valve Mechanism - Remove
Generator Set Control Panel for Switchgear Conversion CID 0175 FMI 08 Temperature Sensor (Engine Oil) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0248 FMI 02 CAT Data Link Incorrect - Test
Generator Set Control Panel for Switchgear Conversion CID 0460 FMI 08 Pressure Sensor (Fuel) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0819 FMI 02 Display Data Link Incorrect - Test