Front Cover - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the gasket and front cover (6) on the front housing. Install nut (5).
Show/hide table
Illustration 2 g01102134 - Install bolts (3) and nut (4) in the front of the cover.
Show/hide table
Illustration 3 g01102133 - Position bracket assembly (2) and install bolts (1).
Show/hide table
Illustration 1 | g01102138 |
End By:
- Install the heat exchanger. Refer to Disassembly and Assembly, "Heat Exchanger - Install".
- Install the water temperature regulator housing. Refer to Disassembly and Assembly, "Water Temperature Regulator - Remove and Install".
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Front Cover - Remove
G3408 and G3412 Engines Electrical System
G3606 and G3608 Engines Valve Cover - Remove and Install
G3408 and G3412 Engines Air Starting System
G3408 and G3412 Engines Basic Block
G3606 and G3608 Engines Crankcase Breather - Remove and Install
3412E, C30 and C32 Marine Engines Vibration Damper and Pulley - Remove and Install
Alignment of Two-Bearing Generators{4471} Alignment of Two-Bearing Generators{4471}
3600 Distillate Fuel Engines Engine Power Ratings
Generator Set Control Panel for Switchgear Conversion CID 0100 FMI 08 Pressure Sensor (Engine Oil) Abnormal Signal - Test
G3408 and G3412 Engines Cooling System
G3606 and G3608 Engines Flywheel and Coupling Guards - Remove and Install
Generator Set Control Panel for Switchgear Conversion CID 0102 FMI 08 Pressure Sensor (Boost) Abnormal Signal - Test
G3606 and G3608 Engines Rocker Arm - Remove
G3606 and G3608 Engines Rocker Arm - Install
Generator Set Control Panel for Switchgear Conversion CID 0110 FMI 08 Temperature Sensor (Engine Coolant) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0172 FMI 04 Temperature Sender (Inlet Air) Voltage Below Normal - Test
Electric Protection System Energize-To-Shutoff (ETS) For Generator Set, Industrial and Marine Diesel Engines Troubleshooting the ETS Partial Protection System (OP, WT) - 3200-3400 Engines
G3606 and G3608 Engines Valve Mechanism - Remove
Generator Set Control Panel for Switchgear Conversion CID 0175 FMI 08 Temperature Sensor (Engine Oil) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0248 FMI 02 CAT Data Link Incorrect - Test
Generator Set Control Panel for Switchgear Conversion CID 0460 FMI 08 Pressure Sensor (Fuel) Abnormal Signal - Test
Generator Set Control Panel for Switchgear Conversion CID 0819 FMI 02 Display Data Link Incorrect - Test
797 Off-Highway Truck Power Train Relief Valve (Torque Converter Inlet)