Cylinder Liner
Usage:
(1) Bore in liner (new) ... 158.78 ± 0.03 mm (6.251 ± .001 in.)
"Use again" maximum bore (when measured near upper end of the wear surface of the cylinder liner) ... 158.90 mm (6.256 in.)
(2) Thickness of flange on liner ... 12.827 ± 0.020 mm (.5050 ± .0008 in.)
(3) Filler Band.
Installation procedure:
Put liquid soap on seals, liner grooves and bore in cylinder block. Install seals on bottom of liner. Put filler band in SAE 30 oil for a moment, then install it on the liner. Install the liner in the cylinder block immediately after the band is installed on the liner (before expansion of the band).
NOTE: Make reference to Guideline For Reusable Parts; Pistons, Form No. SEBF8049.
Caterpillar Information System:
G379, G398 & G399 ENGINES Cylinder Block (Earlier)
G379, G398 & G399 ENGINES Water Temperature Regulator
G379, G398 & G399 ENGINES Auxiliary Water Pump
G379, G398 & G399 ENGINES Fresh Water Pumps
G379, G398 & G399 ENGINES Prelube Pump
G379, G398 & G399 ENGINES Turbocharger Lubrication Valve
G379, G398 & G399 ENGINES Oil Filter
G379, G398 & G399 ENGINES Engine Oil Pressure
G379, G398 & G399 ENGINES Oil Pump Relief Valves
G379, G398 & G399 ENGINES Oil Pump
G379, G398 & G399 ENGINES Valves
G379, G398 & G399 ENGINES Turbocharger (Schwitzer 4MD455 And 4MD755)
G379, G398 & G399 ENGINES Cylinder Liner Projection (Earlier)
G379, G398 & G399 ENGINES Cylinder Block (Later)
G379, G398 & G399 ENGINES Cylinder Liner Projection (Later)
G379, G398 & G399 ENGINES Pistons And Rings
G379, G398 & G399 ENGINES Crankshaft
G379, G398 & G399 ENGINES Connecting Rod
G379, G398 & G399 ENGINES Connecting Rod Bearings
G379, G398 & G399 ENGINES Main Bearings
G379, G398 & G399 ENGINES Bearing Surface (Journal) For Connecting Rods
G379, G398 & G399 ENGINES Bearing Surface (Journal) For Main Bearings
G379, G398 & G399 ENGINES Vibration Damper
G379, G398 & G399 ENGINES Front Accessory Drive