Engine Speed/Timing Sensors - Check/Clean/Calibrate
Show/hide table
Illustration 1 | g00434728 |
Left side view (1) Speed-timing sensor |
Show/hide table
Illustration 2 | g00434865 |
Right side view (2) Backup speed-timing sensor |
- Remove the speed-timing sensors from the front housing. Check the condition of the plastic end of the speed-timing sensors for wear and/or contaminants.
- Clean the metal shavings and other debris from the face of the speed-timing sensors. Use the procedure in the Service Manual in order to calibrate the speed-timing sensors.
Refer to the Service Manual for more information on the speed-timing sensors.
Caterpillar Information System:
3126E and 3126B Commercial and Truck Engines Severe Service Application - Check
3512 Industrial Engine Diagnostic Flash Code Retrieval
3512 Industrial Engine Diagnostic Lamp
3126E and 3126B Commercial and Truck Engines Air Dryer - Check
3512 Industrial Engine Self-Diagnostics
3126E and 3126B Commercial and Truck Engines Air Compressor Filter - Clean/Replace
3512 Industrial Engine Reference Material
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Housing (Front)
C-10 and C-12 Truck Engines Air Inlet And Exhaust System
3406E and 3456 Industrial Engines Electrical System
3126 HEUI Industrial Engine Cooling System
3512 Industrial Engine Alarms and Shutoffs
3126E and 3126B Commercial and Truck Engines Water Pump - Inspect
3126 Truck Engine (Military) Federal Emission Control Warranty
3512 Industrial Engine Permanent Fault Logging
3512 Industrial Engine Engine Operation with Active Diagnostic Codes
3126 HEUI Industrial Engine Fuel System
3126 Truck Engine (Military) California Emission Control Warranty Statement
3126 Truck Engine (Military) Emissions Warranty Information
3116 Truck Engine Reference Material
3126E and 3126B Commercial and Truck Engines Engine Protection Plans
3126 Industrial Engine Fuel Filter Lines
3512 Industrial Engine Customer Specified Parameters
3126B Marine Engine Fuel Filter Base