Housing (Front)
Show/hide table
Illustration 1 | g00465024 |
Front housing |
Note: Make sure that the fuel pump is removed before the front housing is removed.
(1) Front housing
(2) Two gaskets and a plate
The plate is installed between the two gaskets.
Note: Note the positions of the bolts when the bolts are removed. The bolts have different lengths.
(3) Tighten the bolts for the front housing to the cylinder block evenly to the following torques:
- M6 ... 11 N·m (8 lb ft)
- M8 ... 22 N·m (16 lb ft)
- M10 ... 44 N·m (32 lb ft)
- M8 ... 22 N·m (16 lb ft)
Note: The sizes of the bolts may be different on different engine models.
Show/hide table
Illustration 2 | g00465025 |
Locating pin for the oil pump |
When the front housing is installed, make sure that the following components are installed or adjusted:
- Connect the link from the front housing to the fuel injection pump.
- Position the locating pin (6) in the hole of the cover plate (5) for the oil pump.
- Turn the mechanical stop lever (4) clockwise in order to aid the installation of the front housing.
Caterpillar Information System:
C-10 and C-12 Truck Engines Air Inlet And Exhaust System
3406E and 3456 Industrial Engines Electrical System
3126 HEUI Industrial Engine Cooling System
3512 Industrial Engine Alarms and Shutoffs
3406E and 3456 Industrial Engines Cooling System
3126E and 3126B Commercial and Truck Engines Fuel System Water Separator - Drain
3406E Truck Engine Fuel Transfer Pump
3126E and 3126B Commercial and Truck Engines Fuel System Secondary Filter - Replace
3126E and 3126B Commercial and Truck Engines Fuel System Primary Filter - Clean/Replace
3406E and 3456 Engines for Caterpillar Built Machines Lubrication System
3512 Industrial Engine Engine Speed Governing
3406E Truck Engine Fuel Filter Base
3512 Industrial Engine Reference Material
3126E and 3126B Commercial and Truck Engines Air Compressor Filter - Clean/Replace
3512 Industrial Engine Self-Diagnostics
3126E and 3126B Commercial and Truck Engines Air Dryer - Check
3512 Industrial Engine Diagnostic Lamp
3512 Industrial Engine Diagnostic Flash Code Retrieval
3126E and 3126B Commercial and Truck Engines Severe Service Application - Check
3406E and 3456 Industrial Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
3126E and 3126B Commercial and Truck Engines Water Pump - Inspect
3126 Truck Engine (Military) Federal Emission Control Warranty
3512 Industrial Engine Permanent Fault Logging
3512 Industrial Engine Engine Operation with Active Diagnostic Codes