Brake Accumulator (Parking, Service) - Assemble
组装步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 372-6054 | 冲头总成 | 1 |
| B | 291-5047 | 密封件安装工具 | 1 |
| C | 291-5046 | 活塞安装工具 | 1 |
| D | 5P-0960 | 含钼润滑脂 | 1 |
- 将 O 形密封圈 (10) 安装到端盖 (3) 上。 对端盖 (5) 重复该步骤。
Show/hide table
 | |
| 图 1 | g03066540 |
- 使用工具 (B) ，将活塞密封件 (9) 、端部密封件和支承环 (8) 以及承磨环 (7) 安装到活塞 (6) 上。
Show/hide table
 | |
| 图 2 | g03066486 |
- 组装前，将工具 (D) 涂覆到 O 形密封圈、承磨环、支承环和活塞上。
- 使用工具 (C) 安装活塞 (6) 。
Show/hide table
 | |
| 图 3 | g03066476 |
- 使用工具 (A) 安装端盖 (5) 和端盖 (3) 。
Show/hide table
 | |
| 图 4 | g03066340 |
Show/hide table
 | |
| 图 5 | g03066377 |
- 将端盖 (5) 和端盖 (3) 拧紧至扭矩为 300 ± 15 N·m (221 ± 11 lb ft)。
- 安装接头 (4) 。
- 安装弯头 (2) 。 安装阀 (1) 。 将弯头 (2) 和气阀 (1) 拧紧至扭矩为 35 ± 1.5 N·m (26 ± 1 lb ft)。 将气阀保护罩拧紧至扭矩为 1.6 ± 0.1 N·m (14 ± 1 lb in)。
Show/hide table
 | |
| 图 6 | g03066098 |
- 充注蓄能器。
Show/hide table
 |
干燥氮气是唯一被认可用来给蓄能器充气的气体。 对蓄能器充氧气会引起爆炸。 使用带有标准 CGA（压缩气体产业协会，Compressed Gas Association, Inc.） 580 号接头的氮气罐可避免发生爆炸。 订购氮气罐时，务必订购带有 CGA 580 号接头的氮气罐。 不要依赖颜色代码或其它标识方法来区别氮气罐与氧气罐。 在任何情况下，都不能用同一个适配器把充氮总成连接到氮气、氧气或其它气体罐共用的阀出口上。 确保使用的是干燥氮气（纯度 99.8%）。 |
- 请参阅测试和调整, "转向蓄能器 - 测试和充压"。
End By: 安装转向蓄能器。
Caterpillar Information System:
793F Off-Highway Truck Machine Systems Brake Accumulator (Parking, Service) - Disassemble
563C and 573C Wheel Feller Bunchers Engine Air Filter Primary Element - Clean/Replace
Transmission Shaft Welds May Fail on Certain Motor Graders{3063, 3155, 3170} Transmission Shaft Welds May Fail on Certain Motor Graders{3063, 3155, 3170}
3516B Generator Set Engines with Dynamic Gas Blending Engine Does Not Crank
Procedure to Replace the Limit Switch Sensors on Certain PM-200 Cold Planers{1435} Procedure to Replace the Limit Switch Sensors on Certain PM-200 Cold Planers{1435}
AP300D Asphalt Paver Machine Systems Gear Pump (Vibratory)
AP300D Asphalt Paver Machine Systems Radiator Mounting
AP300D Asphalt Paver Machine Systems Muffler
AP300D Asphalt Paver Machine Systems Fuel Tank
Electric Generator Maintenance for AP300 Asphalt Paver{4450} Electric Generator Maintenance for AP300 Asphalt Paver{4450}
AP300D Asphalt Paver Machine Systems Air Cleaner
Installing the 433-2579 Electric Coupler Kit {1408, 6129} Installing the 433-2579 Electric Coupler Kit {1408, 6129}
966M Tier 4, 966M Tier 4 Series XE, 972M Tier 4 and 972M Tier 4 Series XE Wheel Loaders Fuel Tank - Remove and Install
2013/01/31 Improved Joystick Button Now Used on Wheel Feller Bunchers {5705}
563D and 573D Wheel Feller Buncher Operation
2013/02/19 New Seal Rings and Pistons Are Now Used in the Transmission Clutches for Certain 14M and 16M Motor Graders {3155}
986H Wheel Loader Machine Systems Differential Pinion Preload - Adjust
836K Landfill Compactor and 834K Wheel Dozer Diagnostic Trouble Codes
MH3049 Material Handler Hydraulic System Location of Components (Machine System)
NEHS1111: 368-9910 Multi-Tool Group 3 {0599, 0701, 0702, 0706, 1000, 7610, 7620} NEHS1111: 368-9910 Multi-Tool Group 3 {0599, 0701, 0702, 0706, 1000, 7610, 7620}
AD45B Underground Articulated Truck Machine Systems Diverter Valve (Secondary Steering) - Assemble
986H Wheel Loader Machine Systems Glossary of Terms
2013/04/17 The Walkway Group Has Been Improved on Certain 793F Off-Highway Trucks {7255, 7256}
2013/01/31 Anti-Splash Tape is Available for use with Current Fuel Line Shield Groups used on 3500 Machine Engines {1067, 1252}