Problem Number 14 Generator Load Lamp Is On
Usage:
GENERATOR LOAD LAMP
Diagnosis:
The Electronic Locomotive Control is allowing the generator to load by attempting to provide current to the exciter coil. This is in response to a command at the Generator Load Input (Connector J1 pin 1). If the Locomotive electrical system is not supplying a command to load the generator, the Electronic Locomotive Control box is bad. Replace the Electronic Locomotive Control box according to Installation Guide 1.
Caterpillar Information System:
Caterpillar Electronic Locomotive Control System II Problem Number 13 Engine Overspeeds
Caterpillar Electronic Locomotive Control System II Problem Number 10 Rack Position Sensor Fault
Caterpillar Electronic Locomotive Control System II Problem Number 9 Engine Speed Sensor Fault
Caterpillar Electronic Locomotive Control System II Problem Number 8 Personality Module Fault
Caterpillar Electronic Locomotive Control System II Problem Number 7 Cab Mounted Warning Light Turns On
Caterpillar Electronic Locomotive Control System II Problem Number 6 Engine Speed Not Constant
Caterpillar Electronic Locomotive Control System II Problem Number 5 Engine Will Not Respond To Throttle
Caterpillar Electronic Locomotive Control System II Problem Number 4 Generator Power Is Incorrect In One Or More Notches
Caterpillar Electronic Locomotive Control System II Problem Number 3 Engine Will Not Carry Load Or Loads Erratically
Caterpillar Electronic Locomotive Control System II Problem Number 2 Engine Will Not Start
Caterpillar Electronic Locomotive Control System II Problem Number 1 Fuel Linkage Has Limited Travel, Binds Or Takes Excessive Force
Caterpillar Electronic Locomotive Control System II Introduction
Caterpillar Electronic Locomotive Control System II Problem Number 15 Shutdown Lamp Is On
Caterpillar Electronic Locomotive Control System II Problem Number 16 Wheel Slip Lamp Is On
Caterpillar Electronic Locomotive Control System II Problem Number 17 Box Fault Lamp Is On
Caterpillar Electronic Locomotive Control System II Problem Number 18 Engine Shuts Down
Caterpillar Electronic Locomotive Control System II Testing And Adjusting
Caterpillar Electronic Locomotive Control System II 1. Mounting Plate Assembly
Caterpillar Electronic Locomotive Control System II 2. Input-Output Connections
Caterpillar Electronic Locomotive Control System II 3 Locomotive Electrical System Modification
Caterpillar Electronic Locomotive Control System II 4 Discussion
SUPPLEMENT FOR 3116 & 3126 MARINE ENGINE Introduction
SUPPLEMENT FOR 3116 & 3126 MARINE ENGINE Heat Exchanger Group (Sea Water)
SUPPLEMENT FOR 3116 & 3126 MARINE ENGINE Hydraulic Pump Drive Mounting Group (Front)