Oil Filter Base
Usage:
Remove And Install Oil Filter Base
1. Remove filter assemblies (5).
2. Remove elbow (4) and the gasket. Remove the O-ring seal from the tube.
3. Fasten a hoist and tooling (A) to oil filter base (3).
4. Remove bolts (1) and the bolts holding the bottom of the oil filter base to the straps.
5. Remove oil filter base (3). The weight of the oil filter base is approximately 39 kg (86 lb) for an oil filter base with four filter assemblies.
6. Remove tube (2). Remove the O-ring seals from the tube.
NOTE: Put clean oil on all seals before assembly.
NOTE: For installation of the oil filter base, reverse the removal steps.
7. Fill the engine with oil to the correct level. See the Maintenance Manual.
Caterpillar Information System:
3500 GENERATOR SET ENGINES Oil Pump
3500 GENERATOR SET ENGINES Fuel Transfer Pump
3500 GENERATOR SET ENGINES Fuel Filter Base
3500 GENERATOR SET ENGINES Water Pump
3500 GENERATOR SET ENGINES Water Temperature Regulators
3500 GENERATOR SET ENGINES Contactor Group
3500 GENERATOR SET ENGINES Manual Shutoff
3406 SPARK IGNITED ENGINE ATTACHMENTS Testing and adjusting
3406 SPARK IGNITED ENGINE ATTACHMENTS Systems Operation
3406 SPARK IGNITED ENGINE ATTACHMENTS Air Starting Motor 7W0301 (Ingersoll-Rand No. SS350R/7W0301)
3406 SPARK IGNITED ENGINE ATTACHMENTS Pressure Regulating Valve For Air Starting Motor
3406 SPARK IGNITED ENGINE ATTACHMENTS Coolant Level Switch
3500 GENERATOR SET ENGINES Oil Pan
3500 GENERATOR SET ENGINES Oil Cooler
3500 GENERATOR SET ENGINES Turbochargers
3500 GENERATOR SET ENGINES Exhaust Elbow
3500 GENERATOR SET ENGINES Aftercooler
3500 GENERATOR SET ENGINES Air Inlet Manifold
3500 GENERATOR SET ENGINES Exhaust Manifold
3500 GENERATOR SET ENGINES Governor Actuator
3500 GENERATOR SET ENGINES Governor Actuator Drive
3500 GENERATOR SET ENGINES Governor Fastener Group
3500 GENERATOR SET ENGINES Accessory Drive (Front)
3500 GENERATOR SET ENGINES Oil And Water Pump Drive