Correction to Operation and Maintenance Manual , "Equipment Lowering with Engine Stopped" {7000}
- Landfill Compactor:
- 836G (S/N: BRL1-UP; 7MZ1-UP)
- Wheel Tractor:
- 834G (S/N: BPC1-UP; 6GZ1-UP)
The following information should be added to the information that is found in the operation section.
Show/hide table
 | |
| Illustration 1 | g00933394 |
Location of the access hole for the ball valve | |
Show/hide table
 | |
| Illustration 2 | g00931690 |
The control valve for the 834G Wheel Tractor is shown. The control valve for the 836G Landfill Compactor is similar. | |
If the work tool will not lower, a problem may exist with the pilot valve. A ball valve is located near the right rear side of the main control valve. The ball valve can be accessed through a hole in the cover for the main control valve. The ball valve (1) is used for lowering the work tool. Rotate the valve until the slot in the valve is parallel to the line in order to lower the work tool.
Caterpillar Information System:
Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070} Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070}
Bench Test Procedure for Hydraulic Piston Pumps{5070} Bench Test Procedure for Hydraulic Piston Pumps{5070}
14H Motor Grader Machine Systems Wheel Lean Bar - Remove and Install
Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}
14H Motor Grader Machine Systems Blade Lift Cylinder - Remove and Install
CB-634D Paving Compactor Machine Electronic Control System Service Tools
574B Forwarder Power Train On/Off Switches
TH210 and TH215 Telehandlers Power Train Parking Brake Control - Remove and Install
D350E and D400E Articulated Trucks Power Train Solenoid Valve (Lockup Clutch)
D350E and D400E Articulated Trucks Power Train Lockup Clutch and Solenoid Valve
574B Forwarder Power Train Accelerator Pedal
3054E Industrial Engine Camshaft Bearings - Remove and Install
2002/10/21 A Special Instruction, REHS1252, "Field Installation of Body Exhaust Arrangements" Is Available {1061, 7258}
14H Motor Grader Machine Systems Combination Valve - Remove
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Pump Control (Output Flow) - Adjust
14H Motor Grader Machine Systems Bank Valve - Remove
14H Motor Grader Machine Systems Bank Valve - Install
14H and 16H Motor Graders Hydraulic and Steering System Hydraulic Schematic
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
AP-655C and BG-2255C Asphalt Pavers Propel System Pressure Limiter Valve - Test and Adjust
938G Wheel Loader, 938G Series II Wheel Loader, IT38G Integrated Toolcarrier and IT38G Series II Integrated Toolcarrier Traction Control System Test/Enable Switch
574B Forwarder Power Train Introduction
C15 Petroleum Generator Set Engines Electric Starting Motor
3126B Machine Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test