C15 Petroleum Generator Set Engines Caterpillar


Electric Starting Motor

Usage:

C15 115


图 1g02563097

表 1
207-1564 电起动马达总成的技术规格 
项目  数量  零件  技术规格说明 
小齿轮和壳体之间的间隙为 9.1 mm (0.36 in)。 
6V-8188 螺母  拧紧至扭矩为 30.5 ± 3.5 N·m (270 ± 31 lb in)。 
250-8279 电磁阀套件  20V 和 25 °C (77 °F) 下的耗电量:
1. 对于吸合电流为 57 安培
2. 对于保持电流为最大 16 安培 
6V-8188 螺母  拧紧至扭矩为 30.5 ± 3.5 N·m (270 ± 31 lb in)。 
6V-8378 螺母  拧紧至扭矩为 2.25 ± 0.25 N·m (20 ± 2 lb in)。 
6V-8188 螺母  蓄电池端子螺母(5)最多可使用三个电缆或导线端子。 两个端子最高不低于 0 AWG。
拧紧至扭矩为 30.5 ± 3.5 N·m (270 ± 30 lb in)。 
6V-8378 螺母  拧紧至扭矩为 2.25 ± 0.25 N·m (20 ± 2 lb in)。 
拧紧至扭矩为 8 ± 3 N·m (71 ± 27 lb in)。 
当从小齿轮端观看电起动马达时,马达顺时针旋转。
25 °C (77 °F) 时无负载
1. 转速为 7643 ± 1683 rpm
2. 电流消耗为 76.5 ± 14.5 安培
3. 电压为 23 V 

Caterpillar Information System:

574B Forwarder Power Train Introduction
938G Wheel Loader, 938G Series II Wheel Loader, IT38G Integrated Toolcarrier and IT38G Series II Integrated Toolcarrier Traction Control System Test/Enable Switch
AP-655C and BG-2255C Asphalt Pavers Propel System Pressure Limiter Valve - Test and Adjust
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
14H and 16H Motor Graders Hydraulic and Steering System Hydraulic Schematic
14H Motor Grader Machine Systems Bank Valve - Install
14H Motor Grader Machine Systems Bank Valve - Remove
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Pump Control (Output Flow) - Adjust
14H Motor Grader Machine Systems Combination Valve - Remove
2002/10/21 A Special Instruction, REHS1252, "Field Installation of Body Exhaust Arrangements" Is Available {1061, 7258}
2002/10/28 Correction to Operation and Maintenance Manual , "Equipment Lowering with Engine Stopped" {7000}
Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070} Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070}
3126B Machine Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
AP-655C and BG-2255C Asphalt Pavers Drag Conveyor and Auger Conveyor Systems Piston Pump Flow - Test - Upper and Lower Pump Stacks
2002/10/28 Systems Operation/Testing and Adjusting, SENR1456, "793C and 793C XQ Off-Highway Truck Suspension Cylinders" has been Revised {7201}
14H and 16H Motor Graders Air System and Brakes Quick-Release Valve
3054E Industrial Engine Flywheel - Remove
TH210 and TH215 Telehandlers Machine Systems Fender - Remove and Install
TH340B, TH350B, TH355B, TH360B, TH460B and TH560B Telehandlers Seat - Remove and Install
2002/10/28 Correction to Operation and Maintenance Manual , "Bogie and Idler - Inspect/Replace" {4159, 4159, 4192, 4192}
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Piston Motor (Swing Drive) Case Drain Oil - Measure
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Travel Motor Case Drain Oil - Measure
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Relief Valve (Main, Load Sensing) - Test and Adjust
14H Motor Grader Machine Systems Wheel Spindle - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.