Water Separator and Fuel Filter (Primary) - Remove and Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 187-2718 | Filter Wrench As | 1 |
- Open the engine enclosure. Engage the hood support.
- Turn the battery disconnect switch to the OFF position.
Show/hide table
Illustration 1 g06131977 - Loosen the clamps and remove hoses (3).
- Drain water separator (5). Refer to Operation and Maintenance Manual, "Fuel Tank Water and Sediment - Drain" for the correct draining procedure.
- Remove water separator (5) from fuel filter (4).
- Use Tooling (A) to remove fuel filter (4) from fuel filter base (2).
- Remove two bolts (1) and fuel filter base (2).
- Install water separator (5) in the reverse order of removal.
- Use Tooling (A) to install fuel filter (4) to fuel filter base (2).
- Refer to Operation and Maintenance Manual, "Fuel Tank Water and Sediment - Drain" for the correct filling procedure.
Caterpillar Information System:
990K Wheel Loader Systems Steering Control Group
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Air Cleaner Dust Valve - Clean/Inspect
416F2, 420F2 and 430F2 Backhoe Loaders Engine Air Filter Primary Element - Clean/Replace
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Transmission Oil Filter - Replace
980L Tier 3 Wheel Loader Machine System Loader Frame to Rear Frame - Connect
R1700 Load Haul Dump Power Train, Steering, Braking, Hydraulic, and Machine Systems Lift and Tilt Cylinder Speed - Check
793D Off-Highway Truck Power Train Drive Shaft (Main)
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager System Schematic
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager Calibration Using Electronic Service Tool
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager Calibration Using Display Module
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager General Information (Calibration)
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager Troubleshooting
Felling Head Limiter Crack Repair Procedure {6712} Felling Head Limiter Crack Repair Procedure {6712}
A New Felling Head Limiter Crack Repair Is Now Available for Certain Felling Heads {6712} A New Felling Head Limiter Crack Repair Is Now Available for Certain Felling Heads {6712}
CB2.5, CB2.7, CB2.9 and CC2.6 Vibratory Utility Compactors Engine Supplement Muffler - Remove and Install
New Gear Assemblies in the Transmission Pump Are Now Used on Certain 793F Off-Highway Trucks {3108, 5073} New Gear Assemblies in the Transmission Pump Are Now Used on Certain 793F Off-Highway Trucks {3108, 5073}
773E Off-Highway Truck Air System and Brakes Air Compressor and Governor - Test and Adjust
An Improved Inner Clutch Seal is Now Available For Certain 700 C-Series Articulated Trucks {3030, 3160} An Improved Inner Clutch Seal is Now Available For Certain 700 C-Series Articulated Trucks {3030, 3160}
2570D and 2670D Wheel Feller Buncher Engine Supplement Nitrogen Oxide Sensor - Remove and Install - Inlet
M325D MH Material Handler Axle Oil Sample - Obtain
2570D and 2670D Wheel Feller Buncher Engine Supplement Nitrogen Oxide Sensor - Remove and Install - Outlet
CCS9 Combination Vibratory Compactor Propel Systems General Information (Propel System)
CCS9 Combination Vibratory Compactor Propel Systems Operator Controls (Propel System)
CCS9 Combination Vibratory Compactor Propel Systems Propel System Components