Fuel Tank Cap and Strainer - Clean
Show/hide table
| 注意 |
|---|
|
在检查、保养、测试、调整及维修产品时，请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前，请准备好盛接液体用的适当容器。 |
燃油箱盖和滤网位于机器左侧驾驶室平台中的检修门下面。
Show/hide table
| |
| 图 1 | g03347248 |
|
(1) 检修门
(2) 燃油箱盖组件 | |
打开左侧 ROPS 立柱旁的检修门 (1)，以便维修燃油箱盖组件 (2)。
Show/hide table
| |
| 图 2 | g03347330 |
|
(3) 燃油箱盖呼吸器组件
(4) 呼吸器密封垫 (5) 燃油箱盖 (6) 燃油箱盖 O 形密封圈 (7) 尼龙垫圈 (8) 安装螺钉 (9) 操纵杆 | |
本机器上的燃油箱盖呼吸器组件 (3) 无法清洁。 需要维修时，必须更换新的燃油箱盖呼吸器组件。
- 笔直提起杆 (9) 并逆时针转动杆几度，直到杆停止。 然后，提起燃油箱盖 (5) 而不要转动，以便拆下盖。
- 将两个安装螺钉 (8) 和两个尼龙垫圈 (7) 从燃油箱盖 (5) 底侧拆下。 妥善废弃安装螺钉和尼龙垫圈。
- 将燃油箱盖呼吸器组件 (3) 和呼吸器密封垫 (4) 从燃油箱盖上拆下。 妥善废弃呼吸器组件和呼吸器密封垫。
- 用清洁、不易燃的溶剂清洗燃油箱盖。
- 检查燃油箱盖 O 形密封圈 (6) 有无损坏。 必要时，更换密封件。
- 使用呼吸器组件中包含的新呼吸器密封垫、尼龙垫圈和安装螺钉，将新的燃油箱盖呼吸器组件安装到燃油箱盖上。
- 拆下加注口上的滤网。
- 在清洁不易燃的溶剂中清洗滤网。
- 安装加注口的滤网。
- 安装燃油箱盖。
- 顺时针转动杆 (9) 几度，并降下杆，以便将燃油箱盖锁定在已安装位置。
Caterpillar Information System:
C7.1 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C7.1 Engines for Caterpillar Built Machines Air in Fuel - Test
C7.1 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
C7.1 Engines for Caterpillar Built Machines Power Sources
Buffer Seal Assembly May Wear and Cause Leaks in the head of the Lift Cylinder on Certain Track-Type Tractors and Wheel Dozers{5102} Buffer Seal Assembly May Wear and Cause Leaks in the head of the Lift Cylinder on Certain Track-Type Tractors and Wheel Dozers{5102}
C7.1 Engines for Caterpillar Built Machines Electronic Control System
336F MHPU Mobile Hydraulic Power Unit Machine System Specifications Control Valve
336F and 340F Excavators Machine System Specifications Swing Gear and Bearing
259D, 279D, 289D, 299D and 299D XHP Compact Track Loaders, 257D, 277D, 287D, 297D and 297D XHP Multi Terrain Loaders and 236D, 242D, 246D, 262D, 272D and 272D XHP Skid Steer Loaders Machine Systems Refrigerant Condenser - Remove and Install
966M Tier 4, 966M Tier 4 Series XE, 972M Tier 4 and 972M Tier 4 Series XE Wheel Loaders Manual Valve - Remove and Install
2013/02/19 An Improved Transmission Pressure Sensor is Now Used on Certain Pipelayer, Track-Type Loaders, and Track-Type Tractors {1408}
Procedure to Install an Improved Air Cleaner Group for the Rear Engine on Certain 627H Wheel Tractor-Scrapers{1051} Procedure to Install an Improved Air Cleaner Group for the Rear Engine on Certain 627H Wheel Tractor-Scrapers{1051}
Rear Axle Bolted Joint Modified On Certain 994H Wheel Loaders {3013, 3268, 3278} Rear Axle Bolted Joint Modified On Certain 994H Wheel Loaders {3013, 3268, 3278}
990K Wheel Loader Fuel Tank Water and Sediment - Drain
D10T2 Track-Type Tractor Sensor Supply - Test
966M Tier 4, 966M Tier 4 Series XE, 972M Tier 4 and 972M Tier 4 Series XE Wheel Loaders Diesel Exhaust Fluid Module - Remove and Install
D10T2 Track-Type Tractor Systems Inlet Manifold
903C Compact Wheel Loader Safety Messages - Work Tools
986H Wheel Loader Machine Systems Piston Pump (Brake) Pressure - Test and Adjust
901C, 902C and 903C Compact Wheel Loaders Emissions Certification Film
D8T, D9T and D10T2 Track-Type Tractors VIMSTM 3G / Product LinkTM Diagnostic Trouble Codes
903C Compact Wheel Loader Equipment Lowering with Engine Stopped
986H Wheel Loader Machine Systems General Information (Steering System) - HMU Steering
D8T, D9T and D10T2 Track-Type Tractors VIMSTM 3G / Product LinkTM CAN Data Link - Test